How much oil does a 2.4 journey take?
For the Dodge Journey equipped with a 2.4-liter engine, the engine oil capacity is about 4.5 quarts (4.3 liters) when you replace the filter. Without replacing the filter, the capacity is roughly 4.2 quarts (4.0 liters). These figures can vary slightly by model year and filter size, so always confirm with the owner’s manual and verify the level with the dipstick after filling.
Understanding the 2.4L Journey engine
The 2.4-liter World I-4 engine used in early Dodge Journeys is designed for a balance of efficiency and reliability. Knowing the correct oil capacity helps ensure proper lubrication and engine longevity, especially for vehicles that cover a mix of city and highway driving.
Below is a concise breakdown of typical oil capacity for this engine variant:
- With engine oil filter installed: 4.5 quarts (approximately 4.3 liters).
- Without the oil filter: about 4.2 quarts (approximately 4.0 liters).
- Recommended oil viscosity: usually 5W-20 or 5W-30, as specified by the owner’s manual or engine code—climate and model year can influence the choice.
Oil capacity figures can vary slightly by year and by whether the engine uses a different filter size. Always rely on the official manual and the dipstick to determine the exact amount for your vehicle.
Oil change steps and reminders
When performing an oil change, follow a standard process to ensure a proper fill and accurate level check:
- Run the engine to warm the oil, then turn off and lift the vehicle safely for drainage.
- Drain old oil completely and replace the oil filter with a new one compatible with the 2.4L engine.
- Pour in the recommended volume gradually, leaving a small margin for expansion, then start the engine and check for leaks.
- Shut off, wait a few minutes, and recheck the dipstick; adjust the oil level to the full mark if needed.
With the oil changed and the level verified, reset the oil change indicator if equipped and record the mileage for future maintenance scheduling.
Model-year considerations
Chrysler and Dodge used the 2.4-liter World engine across multiple models and years. Minor variations in capacity may occur due to different filter configurations or accessory components. If your Journey is from a later year or a different market, consult the specific service manual for exact figures.
Summary
In short, a Dodge Journey with a 2.4-liter engine typically takes about 4.5 quarts of engine oil with a new filter, or roughly 4.2 quarts without a filter. Always verify with the owner’s manual and confirm the level with the dipstick after adding oil. Proper oil capacity supports engine health and reliable performance across varying driving conditions.
