How much oil does a 2.4 l Dodge Avenger take?
The Dodge Avenger with a 2.4-liter engine typically takes about 5.0 quarts of engine oil when you change the oil and replace the filter (roughly 4.7 liters). If you aren’t changing the filter, the capacity is about 4.5 quarts (roughly 4.3 liters).
Oil capacity can vary slightly by model year and engine variant (for example, between the 2.4L World engine family and other 2.4L configurations). Always confirm the exact figure in your owner's manual and verify the level with the dipstick after a service.
Oil capacity specifics
Here are the typical figures cited by service guides and manuals for a standard oil change on the 2.4L Avenger.
- With oil filter changed: 5.0 quarts (4.7 liters)
- Without replacing the filter: 4.5 quarts (4.3 liters)
When performing an oil change, start with the lower value and add oil gradually, checking the dipstick to bring the level to the full mark. This ensures you don’t overfill and helps protect the engine’s seals and performance.
Oil type and viscosity recommendations
Choosing the right oil viscosity and quality is important for engine longevity and fuel efficiency. The 2.4L engines in many Dodge Avenger models commonly call for a 5W-20 viscosity, with 5W-30 acceptable in some climates or if the manual specifies it. Oils should meet current API standards and be appropriate for your climate and driving conditions.
- Viscosity options: 5W-20 is standard for most environments; 5W-30 may be used if the manual allows it or in hotter climates
- Oil quality: Use conventional, synthetic-blend, or full synthetic oil that meets current API service classifications and the vehicle’s specifications
Always refer to the exact service specification in the owner’s manual for your year and trim, and ensure you use a new oil filter during changes. This helps maintain optimal oil pressure and engine protection.
Summary
For a typical 2.4L Dodge Avenger, plan on about 5.0 quarts of oil with a new filter, or about 4.5 quarts without changing the filter. Use the recommended viscosity (commonly 5W-20, with 5W-30 as an alternative in certain conditions) and verify the final oil level with the dipstick after adding oil. When in doubt, consult the owner’s manual or a trusted service professional for your specific model year and engine variant.
How much oil does a 2.4 Dodge Avenger take?
So we're going to clean up all this from any debris uh this engine calls for 4.5 quarts of oil. So um and you'll see it on your oil cap sae.
How much oil does a 2.4 L 4 cylinder engine take?
5.6 quarts (with filter).
What kind of oil does a 2008 Dodge Avenger 2.4 L take?
5W-20
Notes: Full synthetic Dexos. 5W-20.
How much oil does a 2010 Dodge Avenger 2.4 take?
The 2010 Dodge Avenger with the 2.4L engine has an oil capacity of 4.5 US quarts (4.3 liters) when changing the oil and filter. It is important to use SAE 5W-20 motor oil and to check the oil level after refilling, adding more oil as needed to reach the correct level on the dipstick.
- Capacity: 4.5 US quarts (4.3 liters) with a filter change.
- Oil Type: SAE 5W-20 is the recommended viscosity for all temperatures.
- Filter Change: Always replace the oil filter when performing an oil change.
- Final Check: After refilling, start the engine for about 30 seconds, then check the oil level with the dipstick and top off if necessary.
