How much oil does a 2.4-liter Dodge Journey take?
The Dodge Journey's 2.4-liter inline-4 typically requires about 4.5 quarts (roughly 4.3 liters) of engine oil when performing a full change with a new filter. Always verify with the owner's manual or the dipstick, as exact capacity can vary by model year and engine variant.
Understanding the numbers: engine variants and official capacity
Two main variants of the 2.4-liter engine were used across Journey production years. Official capacity figures for these engines are typically given as 4.5 quarts with the filter installed, though some service guides reference a range that can extend to about 4.7 quarts depending on the exact specification and accompanying components. For the most accurate number, consult the owner's manual for your specific VIN and check the oil level after refilling.
What causes small differences?
Differences often come from variations in oil filter size, whether a filter replacement is included in the change, and regional service bulletins that fine-tune numbers for particular model years.
Practical steps for filling and verification
Start with the baseline capacity listed by your manual (around 4.5 quarts with filter). After an initial fill, run the engine briefly, turn it off, wait a few minutes, and then check the dipstick. Add small amounts of oil as needed to reach the full mark, avoiding overfill which can harm seals and emissions equipment.
Oil grade recommendations
Most 2.4-liter Journeys use 5W-20 as the standard viscosity, with 5W-30 recommended in some climates or model years. Always confirm the exact specification in the owner’s manual and follow manufacturer guidance, especially in extreme temperatures.
DIY oil-change reminders
Use a fresh oil filter and the recommended oil type. Properly dispose of used oil, reset the oil life monitor if equipped, and keep a small margin of reserve oil when planning your maintenance schedule.
Summary
In practical terms, a 2.4-liter Dodge Journey typically takes about 4.5 quarts of oil with a new filter. Exact capacity can vary by year and engine variant, so verify with the owner's manual and check the level on the dipstick after filling. Using the correct oil grade and avoiding overfill protects engine health and performance.
How much oil does a Dodge Journey 2.4 L take?
The oil capacity for a Dodge Journey with a 2.4L engine is 4.5 quarts (or about 4.3 liters) of oil, including the filter. It's important to check the oil level after refilling to ensure it's correct.
- Capacity: 4.5 US quarts (with filter)
- Oil Type: The recommended viscosity is 5W-20.
- After Refill: Always check the oil level after adding the oil to ensure it is within the correct range.
Can you put 5W-30 in a Dodge Journey?
6 Liters Of German RAVENOL DXG 5w30 Motor Oil - Meets the Chrysler MS-6395 motor oil quality standard and viscosity required for the 3.6L Dodge Journey gasoline engine.
How much oil does a 2.4 L 4 cylinder engine take?
5.6 quarts (with filter).
What oil does a 2015 Dodge Journey 2.4 take?
STP Full Synthetic Engine Oil 5W-20 5 Quart.
