How much oil does a 3.3 L Toyota Highlander take?
The Highlander’s 3.3-liter V6 typically needs about 5.1 quarts (roughly 4.8 liters) of engine oil when you perform an oil change with a new filter and refill to the proper level.
The 3.3 L Highlander, commonly powered by the 1MZ-FE V6, has an official oil capacity around 5.1 quarts with the filter. Exact amounts can vary slightly by model year, trim, and whether the filter is replaced during an oil change. For accuracy, consult the owner’s manual or Toyota service data and verify the final level with the dipstick after filling.
Official capacity for the 3.3 L Highlander
Here is the figure most owners use for routine oil changes. It reflects the typical quantity needed when installing a new filter and refilling to full.
- 5.1 quarts (approximately 4.8 liters) of engine oil with a new oil filter
Variations by year and the inclusion of a filter can affect the precise amount. If you’re unsure, check the factory service manual or your dealership’s guidance, and always verify the level on a warm engine with the dipstick after filling.
How to check and top up the oil level
After an oil change or when topping up between changes, use these steps to ensure the level is correct and safe for driving.
- Park on level ground and run the engine until it reaches operating temperature, then turn it off and wait a few minutes for the oil to settle.
- Pull out the dipstick, wipe it clean, reinsert it fully, then pull it out again to read the level.
- If the oil level is below the MIN mark, slowly add small amounts of oil, rechecking with the dipstick after each addition to avoid overfilling.
- Use the oil grade specified in your owner’s manual (commonly 5W-20 or 5W-30 depending on year and climate).
- When the level is between the MIN and MAX marks, reinstall the dipstick and close the hood. Start the engine and check for leaks.
Note: Use only the oil grade recommended for your vehicle. Overfilling can cause engine damage and increased pressure; underfilling can lead to inadequate lubrication and overheating.
Summary
The 3.3 L Highlander typically takes about 5.1 quarts (4.8 liters) of engine oil with a new filter during an oil change. Always verify with your manual and check the level with the dipstick after filling. If in doubt, consult a Toyota technician or service manual for your specific year and trim.
How much oil does a 2007 Toyota Highlander 3.3 L V6 take?
The 2007 Toyota Highlander 3.3L engine has an oil capacity of 5 quarts (4.7 liters) with a filter change. The recommended oil viscosity is 5W-30 for most temperatures.
- Capacity: 5 quarts (4.7 liters) with a filter change.
- Recommended Oil: 5W-30.
- After refilling: Always check the oil level after the change to ensure it is correct.
How many quarts of oil does a 3.3 L V6 take?
6.0 qt
Materials
| Variant | Including the Oil Filter |
|---|---|
| All. | 6.0 qt (5.7 L) |
How much oil does a 2005 Toyota Highlander V6 3.3 take?
The 2005 Toyota Highlander with the 3.3L V6 engine has an oil capacity of 5 quarts when changing the oil filter. The recommended oil type is 5W-30.
- Capacity: 5 quarts (with filter)
- Oil Type: 5W-30
- After refill: Always check the dipstick to confirm the oil level is correct after adding the new oil.
How much oil does a 3.3 Toyota Highlander take?
Oil Change Kit For Toyota Highlander 3.3L V6 2008-2010 0W-20 Full Synthetic Oil - 5 Quarts.
