How much oil does a 3.6 l Dodge Grand Caravan take?
About 5.9 quarts (5.6 liters) of engine oil with a full filter change, using 5W-20 synthetic oil for most climates.
Understanding the oil capacity for the 3.6L Grand Caravan matters for maintenance, oil changes, and ensuring the engine stays properly lubricated. The 3.6L Pentastar V6 used in these vans has a published capacity that can vary slightly by model year and whether the measurement includes the oil filter. The most commonly cited figure sits in the roughly 5.7–6.0 quart range (about 5.4–5.7 liters). The typical consensus is about 5.9 quarts (5.6 L) with the filter.
Oil capacity and specifications
Common figures by year
Note: Oil capacity can vary slightly by year and by filter. The following figures reflect common specifications reported for the 3.6L Pentastar in the Grand Caravan.
- 5.9 quarts (5.6 liters) with filter
- 5.7 quarts (5.4 liters) with filter
- 6.0 quarts (5.7 liters) with filter
In practice, start with the value stated in your owner’s manual and confirm the level with the dipstick after adding oil. If you’re between figures, you’re likely within an acceptable range for normal operation.
Oil type and maintenance guidelines
Understanding the correct oil grade and service intervals helps ensure longevity and performance for the 3.6L engine.
- Viscosity: 5W-20 synthetic is the standard recommendation for most climates; 5W-30 may be permitted in hotter climates or per the manual for specific conditions.
- Capacity: Approximately 5.9 quarts (5.6 liters) with filter, though exact figures can vary by year and measurement method.
- Change intervals: Conventional oil is typically changed every 3,000–5,000 miles, while synthetic oil often allows 7,500–10,000 miles or as indicated by the vehicle’s oil life monitor and the owner's manual.
Always follow the exact specifications and intervals listed in your specific model year owner’s manual or on the maintenance schedule provided by Dodge, as guidelines can vary slightly between production runs.
Practical steps for a DIY oil change
If you’re planning to perform an oil change yourself, here are the general steps to follow. This helps ensure you replace the oil correctly and reach the recommended capacity.
- Warm up the engine briefly, then park on a level surface and engage the parking brake.
- Place a drain pan under the oil pan, remove the drain plug, and let the old oil drain completely.
- Remove the old oil filter, prepare the new filter with a thin layer of fresh oil, and install it hand-tight.
- Replace the drain plug, and pour in the recommended amount of new oil (starting with the stated capacity and adding gradually).
- Check the oil level with the dipstick, top off as needed to reach the proper level, run the engine briefly, then recheck for leaks.
- Reset the oil life monitor if equipped, and dispose of old oil and filter according to local regulations.
If you’d rather not do it yourself, a quick service at a shop will typically follow the same capacity guidelines and use the recommended oil grade for your year and climate.
Summary
The 3.6L Dodge Grand Caravan generally requires about 5.9 quarts (5.6 liters) of engine oil with a filter, using 5W-20 synthetic for most conditions. Exact capacity can vary by model year and measurement method, so always consult the owner's manual for your specific vehicle and confirm the level with the dipstick after filling. Regularly changing oil with the correct viscosity helps maintain engine health and performance.
How much oil does a 3.6 Dodge Grand Caravan take?
6 liters 5W-20 Dodge Grand Caravan engine oil and oil filter for 3.6L V6 applications.
How much oil do you put in a 3.6 L V6?
The oil capacity for a 3.6L V6 engine is typically 5 to 6 quarts, but it varies by vehicle model and year. For a 2020 Dodge Charger, it's around 5.9 quarts, while a 2023 Jeep Wrangler requires 5 quarts. Newer Jeeps, such as the 2016-2021 Grand Cherokee and Durango, often require 6 quarts. Always check your specific owner's manual for the most accurate information, as it can differ even within the same engine family.
- 5 quarts: Common in many models like the 2020 Jeep Wrangler and 2025 Ram 1500.
- 5.9 quarts: The capacity for some models, such as the 2020 Dodge Charger.
- 6 quarts: Required for certain vehicles, including the 2013 JK Jeep Wrangler and some 2016-2021 Grand Cherokee and Durango models.
- Check your owner's manual: This is the most reliable source for your specific vehicle's oil capacity.
- After refilling: It's important to check the oil level with the dipstick after refilling to ensure it is correct.
How much oil does a 3.6 liter V6 engine take in a Grand Cherokee?
Engine Oil
Capacity: 5.9 quarts (with filter).
What oil does a Dodge 3.6 V6 take?
The recommended oil for a Dodge 3.6L engine is SAE 0W-20 full synthetic motor oil, though some sources state that SAE 5W-20 is also acceptable and that SAE 5W-30 can be used in hotter climates. The engine typically requires 6 quarts of oil.
Oil type and weight
- Primary recommendation: SAE 0W-20 full synthetic oil.
- Alternative options:
- SAE 5W-20 full synthetic is often listed as an acceptable alternative.
- SAE 5W-30 synthetic can be used, especially in hot climates, according to some sources.
Oil capacity
- The 3.6L V6 engine typically requires 6 quarts of oil.
Important notes
- Always check your vehicle's owner's manual for the most accurate and up-to-date information, as specifications can vary by model year and specific vehicle.
- The oil must meet the manufacturer's specifications, such as the Mopar API certification.
