How much oil does a Ford Figo Aspire 1.5 TDCi Diesel engine take?
The Ford Figo Aspire 1.5 TDCi diesel engine takes roughly 3.5 liters of engine oil for a full drain and refill with a new filter. In everyday service, you’ll typically need about 3.3 to 3.6 liters, depending on the exact engine version and whether the filter is replaced.
Official capacity and practical range
Ford’s service documentation for the 1.5 TDCi Duratorq used in the Figo Aspire lists an oil capacity of about 3.5 liters including the filter. In practice, technicians frequently see fills in the 3.3–3.6 liter range when performing a standard oil change with a new filter.
The following figures help with planning your oil change and purchases:
- Oil capacity (including the filter): about 3.5 liters
- Typical drain-and-fill amount with a new filter: around 3.3–3.6 liters
- Recommended oil grade: 5W-30 full synthetic (climate dependent; 5W-40 can be used in hotter climates)
- Oil change interval: usually every 10,000–15,000 kilometers or as specified in the owner's manual
When planning an oil change, always verify the exact specification for your vehicle's year and market, and keep to the dipstick readings for the final fill.
How to check and refill the oil
If you’re doing the service yourself, follow these steps to ensure you reach the proper level and avoid overfilling:
- Park on level ground, engine off, and allow the oil to settle for a few minutes. If the engine is hot, wait longer and use caution as the oil can be very hot.
- Open the hood and locate the engine oil filler cap and dipstick. Remove the dipstick, wipe clean, reinsert, then pull out to check the current oil level.
- Place a drain pan under the engine and remove the drain plug to empty old oil. Replace the drain plug seal, and install a new oil filter if you’re giving the filter a replacement.
- Fill the engine with the recommended oil, starting with about 3.0–3.2 liters to allow for expansion, then check the level with the dipstick and add small amounts until the level reaches the full mark.
- Run the engine for a minute, switch off, wait a few minutes, and recheck the oil level to confirm it’s at the full mark. Top up modestly if needed.
After refilling, inspect for leaks around the filter and drain plug, and dispose of used oil according to local regulations.
Summary
The 1.5 TDCi Duratorq engine in the Ford Figo Aspire typically uses about 3.5 liters of oil for a full change with a new filter, with a practical range of roughly 3.3–3.6 liters. Use a 5W-30 full synthetic oil, follow the 10,000–15,000 km service interval, and always confirm with the official manual for your year and market.
