How much oil does a Honda CRZ take?
The CR-Z’s 1.5-liter i-VTEC engine requires about 3.7 quarts (3.5 liters) of engine oil for a full change with the filter, using 0W-20 synthetic oil.
In more detail, the CR-Z (produced from 2010 to 2016) combines a 1.5-liter gasoline engine with hybrid components. The official oil capacity refers to a complete drain and filter replacement, but actual amounts can vary slightly by model year or market. Always verify with the owner's manual or dealer for your specific VIN and climate conditions.
Oil capacity and recommended oil
Key specifications you should know before you buy oil or start an oil change.
- Engine oil capacity (with filter): approximately 3.7 quarts (3.5 liters).
- Recommended oil grade: 0W-20 synthetic engine oil (Honda specification, GF-5 or newer).
- Notes: If you replace the oil without the filter or drain only partially, the exact amount can vary slightly; always finish to the correct level using the dipstick.
These figures are generally consistent across model years (2010–2016) and markets, but confirm with the owner’s manual or a Honda dealer for your specific vehicle.
Oil change procedure (high-level)
Guidance for performing a standard oil change while adhering to the recommended oil type and capacity.
- Warm up the engine briefly, then park on level ground and turn off the engine.
- Place a drain pan underneath the oil sump, remove the drain plug, and let the old oil fully drain.
- Remove the old oil filter and replace it with a new filter, lightly coating the new gasket with fresh oil.
- Reinstall the drain plug securely and begin adding fresh oil.
- Pour in about 3.5 quarts (the lower end of the range) of 0W-20 synthetic, then check the level with the dipstick and add in small increments as needed until it reaches the full mark.
- Start the engine, run briefly, check for leaks, then recheck the oil level and top off if necessary.
- Dispose of used oil and the old filter according to local regulations.
Always refer to the owner’s manual for exact steps and torque specs, and adjust for your climate or driving conditions as recommended by Honda or your local dealer.
Summary
The Honda CR-Z uses about 3.7 quarts (3.5 liters) of engine oil for a full change with a new filter, with a recommended viscosity of 0W-20 synthetic. Verify this for your specific model year and market, and use the dipstick to ensure the oil is topped to the correct level after service. Regular oil changes help maintain efficiency and longevity for the hybrid system.
How many quarts of oil does a Honda CRZ take?
All right with the oil drained out we're going to be using oil filter Romeo 84356.
How many quarts of oil does a 1.5 liter engine take?
The Honda Civic with a 1.5L Turbo engine requires approximately 3.7 quarts (3.5 liters) of oil. It's important to use the recommended oil type to ensure optimal performance and longevity of your engine.
How much oil does a 2015 Honda CRZ 1.5 take?
For Automatic Transmission: STYA....VTF06
| Capacity: | 3 quarts Initial Fill. |
|---|---|
| Capacity: | STYA Total Fill 5.5 quarts. |
What oil does a 2012 Honda CRZ take?
The correct oil for a 2012 Honda CR-Z is a full synthetic 0W-20 oil. It's recommended to use Honda Genuine Motor Oil or a premium-grade oil that meets the specified viscosity and API certifications, such as SN Plus, as a substitute for optimal engine performance and protection. The CR-Z requires 3.6 quarts of oil with a filter change, or 3.8 quarts without a filter change.
- Oil Viscosity: 0W-20
- Oil Type: Full Synthetic
- API Certification: SN Plus
- Oil Capacity: 3.8 quarts (with filter), 3.6 quarts (without filter)
