How much oil does a k24 TSX take?
The engine oil capacity for most K24-powered TSX models is about 4.5 quarts (4.3 liters) with the filter installed.
In practice, the exact amount can vary slightly by engine variant and market, so it’s important to verify the specification for your specific car in the owner’s manual or service manual. The K-series engines used in the TSX share a common baseline, but small differences can occur between variants.
Capacity details and variant notes
To help boat the essential figures and caveats, here is a concise outline of the standard capacity and what can affect it.
- Standard capacity for most K24 TSX models (oil with filter installed): 4.5 quarts (4.3 liters).
- Notes: Actual capacity can vary slightly by engine variant and regional specification; always consult the specific service manual for your vehicle to confirm the exact figure.
In practice, rely on the dipstick after adding oil and allow the engine to settle to the proper level to ensure you reach the full mark accurately.
Oil type, checking, and changing steps
Alongside knowing the capacity, using the correct oil grade and following proper change procedure helps maintain engine health. The TSX typically uses a Honda-recommended viscosity, commonly 5W-20 in many markets, though you should use the grade specified in your manual based on climate and model year.
Before performing a change or checking the level, the following steps outline a typical process for the K24 TSX:
- Warm up the engine briefly, then park on level ground and turn off the engine.
- Relieve any built-up pressure, place a drain pan beneath the oil pan, and remove the drain plug to let the old oil drain completely.
- Remove and replace the oil filter with a new one of the correct specification for your engine variant.
- Reinstall the drain plug securely, and pour in a cautious initial pour of 4.5 quarts (4.3 liters) of the recommended oil.
- Start the engine and run for a minute, then turn it off and wait a few minutes for the oil to settle. Check the dipstick and top up in small increments until the level reaches the full mark.
- Dispose of old oil properly and reset any maintenance counters if applicable.
These steps provide a practical framework, but always follow the exact procedure and capacities listed in your vehicle’s manual for your model year and region.
Summary
For most Honda K-series TSX models, you should plan on about 4.5 quarts (4.3 liters) of engine oil with the filter during a standard oil change, with the exact amount verified against your owner’s manual or service manual for your specific variant. Use the recommended oil grade for your climate, and always confirm level with the dipstick after a warm engine check.
How much oil does a 2.4 Acura TSX take?
2006-2008 Acura TSX 2.4L 4 Cyl. Notes: ENEOS Motor Oil 5W-30 (3703-400), 6 Gallon -- Application temperature: temperate climate; 4.4 Quart (qt) Service fill Capacity.
What kind of oil does a K24 TSX take?
The K24 engine is engineered for 5W-20. Thicker oil (10W-30) doesn't flow as well in cold weather, increasing wear on startup. It can also create excessive pressure in the crankcase, leading to leaks or seal damage.
How many quarts of oil does a 2.4 L engine take?
And max line which is good since the oil is still settling to the oil pan i'm measuring a little fast after stopping the engine. So feel free to check again at home after a little while longer.
How much oil does a K24 take?
A Honda K24 engine typically takes 4.2 to 4.5 quarts of oil with a filter change, but the exact amount can vary by model and year. Always check your specific vehicle's owner's manual for the precise capacity and recommended oil viscosity.
- Common capacity: Most Honda K24s require between 4.2 and 4.5 quarts of oil.
- Check your owner's manual: The most accurate information will be in your specific vehicle's manual.
- Recommended oil: Use the oil viscosity (e.g., 5W-20) and type (e.g., synthetic) recommended by the manufacturer.
- Check after a drive: After an oil change, it's a good practice to check the oil level after letting the car sit for a few minutes, as the filter will take some oil to saturate.
