How much oil does a Lexus is220 take?
The Lexus IS220 typically takes about 4.5–5.0 liters of engine oil when performing a full change with a new filter. This range can vary slightly based on the exact engine variant and market.
In practice, the IS220 was offered in several regions with a 2.2-liter inline-four engine, and the precise oil capacity can differ by year, market, and whether the oil filter is replaced. Always consult the owner's manual or a Lexus service bulletin for your specific vehicle to confirm the exact amount.
Oil capacity for the IS220 by engine and market
The IS220 configuration typically uses a 2.2-liter engine, and the official total oil capacity (including the filter) is generally around 4.5 to 5.0 liters (roughly 4.7 to 5.3 quarts). Exact figures can vary by year and by the precise engine code used in your market. For a precise value, verify with the vehicle’s manual or a Lexus service source for your VIN.
Refer to the following reference to guide your fill during an oil change. Note that the exact amount may differ slightly depending on the engine variant and maintenance history.
- Typical total oil capacity (including the filter) for the Lexus IS220 is about 4.5–5.0 liters (roughly 4.7–5.3 quarts).
Because markets and model years vary, treat this as a guideline rather than a guaranteed figure. Always verify the capacity for your exact vehicle using the owner's manual or Lexus dealer data, and never overfill the engine.
How to check and refill oil safely
If you're performing an oil change yourself or topping up, follow these steps to check the level and add oil carefully. Use a suitable funnel and the correct oil grade for your IS220.
- Warm up the engine for a few minutes, then park on level ground and switch off the engine.
- Open the hood and locate the engine oil dipstick; pull it out, wipe clean, reinsert, and pull out again to check the level. The oil should be between the MIN and MAX marks.
- If the level is low, add oil gradually: pour about 0.25–0.5 liters (0.25–0.5 qt) at a time through a funnel, then wait a moment and recheck with the dipstick.
- Continue until the dipstick shows the level in the middle of the range; avoid overfilling.
- Replace the dipstick and close the hood; run the engine for about a minute, then recheck the level after the engine has cooled for a few minutes.
During topping up, ensure you use the oil grade recommended by Lexus for your IS220's year and market (commonly 5W-30 synthetic), and discard used oil properly. If you're unsure, consult a professional.
Summary
The Lexus IS220 generally requires about 4.5–5.0 liters of engine oil for a full change, including the filter, with exact figures varying by market and engine code. Always verify the precise capacity in the owner's manual or through a Lexus service source for your VIN, use the recommended oil grade, and follow proper topping-up procedures to avoid overfilling. Regular checks with the dipstick help ensure optimal oil levels and engine protection.
