How much oil does a Subaru Baja take?
The Subaru Baja with the 2.5-liter engine typically requires about 4.5 quarts (4.3 liters) of engine oil when performing an oil change with a new filter.
For context, the Baja was produced from 2003 to 2006 and uses Subaru's EJ25 2.5L flat-four engine. Oil capacity is generally listed as 4.5 quarts with a new filter, but the exact amount can vary slightly depending on whether you replace the filter and how completely you drain the crankcase. This article lays out the official figure and practical tips for changing the oil on this model.
Oil capacity basics for the Baja
Before listing the numbers, note that the standard capacity assumes a complete drain and a fresh filter. Here is what most Baja owners will encounter during a typical oil change.
- Oil capacity with a new filter: 4.5 quarts (4.3 liters)
- Recommended oil viscosity: 5W-30 for most climates; some owners use synthetic 0W-30 or 5W-40 in extreme temperatures or high-mileage engines, per Subaru guidance
- Practical tip: have a little extra oil on hand (about 0.5 quarts) in case you need to top off after the initial refill and checking the level
In practice, most DIY oil changes result in adding about 4.5 quarts to reach the correct level, with small variations depending on filter choice and how much oil remains in the used filter.
Oil type guidance and climate notes
The EJ25 in the Baja is compatible with a range of viscosities, but 5W-30 remains the baseline recommendation for a broad range of temperatures. In very cold climates, some drivers opt for a thinner grade such as 0W-30; in hotter climates or with higher-mileage engines, a slightly higher viscosity like 5W-40 may be preferred, following Subaru service recommendations. Always check the specific year/manual for your vehicle or VIN.
Bottom line for Baja owners
For most Baja owners, plan to purchase about 4.5 quarts of engine oil and a new filter for an oil change on the 2.5L EJ25, and verify the level with the dipstick after starting the engine and a brief idle. If you’re close to the limit, add small amounts and recheck the level to avoid overfilling.
Summary
The Subaru Baja's 2.5L EJ25 engine typically takes about 4.5 quarts (4.3 L) of oil for a standard oil change with a new filter. Use 5W-30 as the baseline viscosity, and always verify the level with the dipstick after refilling. This guidance covers 2003–2006 Baja models; verify against your specific year and any service bulletins for precise requirements.
How many quarts of oil does a Subaru Baja take?
4.2 quarts
Oil Grade: SM
5W-30 (All TEMPS) - SAE 5W-30 is preferred. Capacity: 4.2 quarts (with filter). After refill check oil level.
How much oil does a 2006 Subaru Baja 2.5 take?
4.2 quarts
Oil Grade: SM
| Viscosity: | 10W-30, 10W-40 (Above -20°C) 5W-30 (All TEMPS) - SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 4.2 quarts (with filter). After refill check oil level. |
| Torque: | 33 ft/lbs (Oil Drain Plug) |
How many quarts of oil does a 3.6 L V6 take?
A 3.6L V6 engine typically takes between 5 and 6 quarts of oil, but the exact amount varies by vehicle model, so you must check your owner's manual or the oil fill cap for the precise capacity. For example, some models like a 2013 Jeep JK require 6 quarts, while newer models like a 2020 Jeep Wrangler or 2018+ Jeep Wrangler JL may only take 5 quarts.
Here are some general guidelines:
- Check your owner's manual: This is the most reliable source for your specific vehicle.
- Look at the oil fill cap: It may have the required viscosity and capacity printed on it.
- Consider the model year: Newer vehicles, especially certain Jeep models, have different oil capacities than older ones.
- Change the oil filter: Always include an oil filter change, as this is part of the full oil capacity.
- After refilling, check the level: After you've filled the engine with oil, use the dipstick to check the oil level and add more if needed to reach the "full" line.
How many quarts of oil does a 3.0 L V6 take?
A 3.0L V6 engine typically takes between 4.5 and 6.5 quarts of oil, but the exact amount depends on the specific vehicle make and model. For example, a 2006 Ford Fusion 3.0L V6 requires 6 quarts, while a 2001 Jaguar S-Type 3.0L V6 needs 6.5 quarts. Always check your vehicle's owner's manual for the precise capacity and oil viscosity requirements.
| Vehicle | Oil Capacity |
|---|---|
| 2012 Ford Escape 3.0L V6 | 6 quarts |
| 2006 Ford Fusion 3.0L V6 | 6 quarts |
| 2003 Ford Ranger 3.0L V6 | 4.5 quarts |
| 2001 Jaguar S-Type 3.0L V6 | 6.5 quarts |
(this||self).Wufxzb=function(c,e,f,l,k){var d=document.getElementById(c);if(d&&(d.offsetWidth!==0||d.offsetHeight!==0)){c=d.querySelector("div");var g=c.scrollWidth-c.offsetWidth,h=Math.min(e?g:0,g);c.scrollLeft=e&&(l||f)?0:h;var a=d.getElementsByTagName("g-left-button")[0],b=d.getElementsByTagName("g-right-button")[0];a&&b&&(e=RegExp("\\btHT0l\\b"),f=RegExp("\\bpQXcHc\\b"),a.className=a.className.replace(e,""),b.className=b.className.replace(e,""),h===0?a.className="pQXcHc "+a.className:(a.className=
a.className.replace(f,""),k&&c.classList.add("pA30Ne")),h===g?b.className="pQXcHc "+b.className:(b.className=b.className.replace(f,""),k&&c.classList.add("FpCCub")),setTimeout(function(){a.className+=" tHT0l";b.className+=" tHT0l"},50))}};}).call(this);(function(){var id='__uQlaYLDIv-gi-gP48bTmAM_150';var rtl=false;var gecko=false;var edge=false;var soh=false;
(this||self).Wufxzb(id,rtl,gecko,edge,soh);})();
