How much transmission fluid does a 2013 Lexus LX 570 hold?
Approximately 11 quarts (roughly 10.5 liters) of ATF WS are needed for a full fill in the 2013 LX 570. The exact amount depends on the service type and whether the transmission filter is replaced or a full system flush is performed.
For context, the LX 570 uses a 6-speed automatic transmission (A750F) that requires Toyota/Lexus World Standard transmission fluid (ATF WS). The total capacity includes fluid in the torque converter and cooler lines, so the amount you add can vary during service. In routine maintenance, draining only the pan and refilling typically replaces about 7–9 quarts, whereas a full system flush can require around 11–12 quarts or more. Always consult the owner's manual or a Lexus technician for the precise figure for your vehicle.
Capacity figures and what they mean
Below is a concise breakdown of the common capacities you'll encounter when servicing the LX 570 transmission.
- Total system capacity: about 11 quarts (10.5 liters) of ATF WS.
- Pan drain and refill (no flush, including the pan filter change where applicable): roughly 7–9 quarts.
- Full system flush or multiple-component replacements: up to about 11–12 quarts.
- Fluid specification: Toyota/Lexus ATF WS (World Standard). Dexron VI is not typically recommended unless specified by Lexus.
Note: Actual volumes can vary slightly by vehicle and service method. Always refer to the precise specifications in the owner’s manual or a Lexus service bulletin.
Practical servicing guidance
Before performing a DIY or dealer service, keep these considerations in mind.
- Use the correct ATF WS specification for the LX 570’s A750F transmission.
- Warm up the transmission to normal operating temperature before draining.
- Replace the transmission filter if applicable during a full fluid change.
- When checking the level, ensure the engine is running and the transmission is in Park or the appropriate position as specified by Lexus.
Following these practices helps ensure accurate fluid levels and optimal transmission performance after service.
Summary
For the 2013 Lexus LX 570, plan on about 11 quarts of ATF WS for a full fill, with pan drain/refill typically in the 7–9 quart range, and flush scenarios around 11–12 quarts. Always verify with the owner's manual or a Lexus technician, and use the recommended ATF WS and servicing procedures to ensure proper operation.
How much transmission fluid does a 2013 Lexus lx570 hold?
Attention: The total dry Lexus LX 570 transmission fill capacity is 11.1 liters or 11.7 quarts. However, due to the transmission design, only about 5.5 liters of Lexus WS transmission fluid will drain when removing the transmission pan and changing the transmission filter.
How much oil does a 2013 Lexus lx570 take?
Capacity: 7.9 quarts (with filter). After refill check oil level.
How many quarts of transmission fluid for a drain and fill?
For a standard transmission fluid drain and fill, you'll typically need 3 to 5 quarts, but you should always measure the amount you drained and refill with the same amount to start, then check the level using the dipstick after running the engine. The exact amount varies by vehicle, and it's crucial to check the owner's manual or look up specifications for your specific make and model, as a drain and fill will not replace all the old fluid.
How to determine the right amount
- Drain the old fluid: Let the old fluid drain completely.
- Measure the drained fluid: Measure how much fluid was drained. This is your starting point for refilling.
- Refill with the measured amount: Put the same amount of new, correct transmission fluid back into the transmission. Using a funnel can help with this process.
- Start the engine: Start the vehicle and let it run for a few minutes, shifting through all the gears (Park, Reverse, Neutral, Drive) while holding the brake. This circulates the new fluid.
- Check the level: Turn the engine off and check the fluid level with the dipstick. Add more fluid in small increments if the level is low, or drain a small amount if it's too high.
- Re-check: Repeat the process of running the engine and checking the dipstick until the fluid level is correct according to the dipstick's hash marks for a "hot" reading.
Important considerations
- A drain and fill is different from a full transmission flush, which requires significantly more fluid (10-12 quarts or more) because it aims to replace all the fluid, including what's in the torque converter.
- You should always use the specific type of transmission fluid recommended by your vehicle's manufacturer to avoid damage.
- Some vehicles, like certain Land Rovers, do not have a dipstick and require a fluid extractor to add new fluid. Consult your owner's manual to be certain.
How much gear oil does a Lexus 570 hold?
How much (quantity of litres) gearbox oil is required for a LX 570 570 (URJ201)? On average, 5 - 10 litres of gear oil is required for automatic and manual transmissions on the LEXUS LX (_J2_) 270 kW / 367 hp.
