How much transmission fluid does a 2017 Ford Transit 250 hold?
The 2017 Ford Transit 250 with an automatic transmission holds roughly 12–13 quarts (about 11–12 liters) of transmission fluid when filled to the proper level. A drain-and-fill service typically uses about 9–11 quarts, depending on the exact transmission variant and service approach.
These figures can vary based on the engine and transmission option (gasoline 3.7L V6, EcoBoost variants, or the 3.2L diesel) and whether you’re performing a simple pan drain or a full transmission flush that also drains the torque converter and cooler lines. For the most precise capacity, consult the vehicle’s owner manual or the Ford service documentation for your VIN.
What affects the capacity
Transmission fluid capacity for the 2017 Transit 250 is not one fixed number. It depends on the specific transmission installed in the vehicle and the service method used. Always verify with official Ford documentation or your dealer for your exact VIN.
- Total capacity (including the torque converter): approximately 12.5–13 quarts (about 11.9–12.3 liters).
- Drain-and-fill capacity (pan drain only, no torque converter drain): roughly 9–11 quarts (about 8.5–10.4 liters).
- Full transmission flush (includes cooler lines and converter): about 12–14 quarts (roughly 11.4–13.3 liters).
Typical service-method capacities you might encounter:
Bottom line: routine drain-and-fill work generally uses around 9–11 quarts, while a complete fill or flush can approach 12–13 quarts or more depending on the variant. Always double-check with the official service data for your VIN.
How to approach servicing safely
If you’re planning to service the transmission yourself, follow these general steps as a guide and refer to the official manual for your exact model and transmission variant. Not all Transit models are identical, and some components may require specialized tools.
- Park on a level surface, apply the parking brake, and chock the wheels. Allow the engine to reach normal operating temperature if a warm level check is required by your manual.
- Locate the transmission dipstick (or follow the manual’s guidance if your model uses a sealed system) and prepare the appropriate transmission fluid type specified for your VIN.
- With the engine running and in Park, check the current fluid level and condition. Fluid should be bright red and free of burnt smell.
- If performing a drain-and-fill, remove the drain plug, allow the pan to drain, then replace the plug and refill in small increments. Recheck the level according to the manual’s procedure.
- For a full flush, connect the proper equipment to flush and refill the transmission through the appropriate port, ensuring all lines and the torque converter are drained and replaced with fresh fluid.
- After refilling, run the vehicle through the gears (Park, Reverse, Drive, and Back to Park) with the engine at idle and the brakes applied, then recheck the level and adjust if necessary.
Caution: use only the fluid type specified by Ford for your transmission. If your Transit is equipped with a sealed system or you’re unsure about the procedure, seek service from a qualified technician rather than attempting a DIY flush.
Summary
For a 2017 Ford Transit 250 with an automatic transmission, expect a total capacity around 12–13 quarts for a full fill, with drain-and-fill services typically requiring about 9–11 quarts. Exact figures vary by engine/transmission variant and service method, so always consult the owner’s manual or Ford’s official service data for your VIN to ensure accuracy.
