How much transmission fluid does a Toyota Tundra take?

The Toyota Tundra typically requires about 11–13 quarts for a full transmission service, or about 7–9 quarts for a simple pan drain and refill; exact capacity depends on the year, model, and transmission code.

As the Tundra has evolved across generations, its automatic transmissions and service procedures have changed. The total fluid volume you need to complete a full service versus a basic drain-and-fill varies by transmission type, so it’s important to verify the exact specification for your truck. Always consult the owner's manual or a Toyota service bulletin for your specific year and transmission code.

Transmission fluid capacity by service type

Below are typical capacity ranges for common Tundra transmission configurations and service approaches.

• Pan drain and refill (no fluid in the torque converter): about 7–9 quarts.


• Full transmission service (drain, refill, including torque converter and cooler lines, with filter replacement where applicable): about 11–13 quarts.

These figures serve as general guidelines. The exact amount required can vary with the generation of the transmission and whether a fluid flush or filter replacement is performed. Always confirm with the exact specification for your vehicle.

How to confirm your exact capacity

To ensure accuracy for your specific year and transmission, use these steps:

1. Locate the transmission code for your Tundra (it's usually specified in the owner's manual or on a label in the engine compartment or VIN plate).


2. Consult Toyota's official service information or the maintenance manual for the capacity chart that matches that transmission code.


3. If you’re unsure, plan for a full system service (roughly 11–13 quarts for many generations) and adjust based on the service performed (drain-and-fill vs. full flush).

Also ensure you use the recommended ATF type for your model year (for many recent Tundras this is Toyota ATF WS or an equivalent high-quality automatic transmission fluid) and replace the filter if your transmission requires one during service.

Summary

In short, a Toyota Tundra’s fluid demand depends on the transmission and the service performed. A pan-drain/refill generally takes about 7–9 quarts, while a full transmission service typically requires about 11–13 quarts. Newer or different transmission codes (such as some 10-speed configurations) may push toward the higher end of that range or slightly above. Always verify the exact capacity for your vehicle using the manual, VIN-based service information, or a dealer.

How many quarts of transmission fluid for Toyota Tundra?

11.6 liters or 12.3 quarts with tow package. Attention: The total dry Toyota Tundra transmission fill capacity is 11.1 liters or 11.7 quarts (11.6 liters or 12.3 quarts with tow package).

How much transmission fluid does a 2013 tundra take?

The total transmission fluid capacity for a 2013 Toyota Tundra depends on the engine size and if it has a tow package, ranging from 11.7 to 12.3 quarts. For a 4.6L V8, the total capacity is 11.7 quarts (3.2 quarts for an initial fill). For a 5.7L V8, it's 11.7 quarts (3.2 quarts for an initial fill) without a tow package and 12.3 quarts (3.2 quarts for an initial fill) with one. A standard drain and refill will only require about 3.2 to 3.5 quarts. 
You can watch this video to learn how to replace the transmission fluid on a 2007-2013 Toyota Tundra: 1mshiftwrenchrepeatYouTube · Oct 4, 2021
Transmission fluid capacity by engine size

• 4.6L V8 (A760F transmission):
  • Total Capacity: 11.7 quarts 
  • Initial Fill: 3.2 quarts 
• 5.7L V8 (AB60F transmission):
  • Total Capacity (no tow package): 11.7 quarts 
  • Total Capacity (with tow package): 12.3 quarts 
  • Initial Fill: 3.2 quarts 

Drain and refill capacity

• A typical drain and refill will only remove about 3.2 to 3.5 quarts of fluid, as much remains in the torque converter and other parts of the transmission. 
• You will need approximately 3.2 to 3.5 quarts of fluid for a standard fluid change, while a full flush will require significantly more.

Important note

• This information is for the 6-speed automatic transmissions. The 2013 Tundra also came with a 5-speed transmission, which has a different capacity. 
• Always use the correct fluid for your vehicle, which is Toyota ATF WS (JWS 3324) for 2013 models. 

How much to change transmission fluid in tundra?

between $172 and $206
The average cost for a Toyota Tundra Transmission Fluid Change is between $172 and $206. Labor costs are estimated between $73 and $107 while parts are typically priced around $98.

How many quarts of transmission fluid do I need for a drain and fill?

For a standard transmission fluid drain and fill, you'll typically need 3 to 5 quarts, but you should always measure the amount you drained and refill with the same amount to start, then check the level using the dipstick after running the engine. The exact amount varies by vehicle, and it's crucial to check the owner's manual or look up specifications for your specific make and model, as a drain and fill will not replace all the old fluid. 
How to determine the right amount

• Drain the old fluid: Let the old fluid drain completely. 
• Measure the drained fluid: Measure how much fluid was drained. This is your starting point for refilling. 
• Refill with the measured amount: Put the same amount of new, correct transmission fluid back into the transmission. Using a funnel can help with this process. 
• Start the engine: Start the vehicle and let it run for a few minutes, shifting through all the gears (Park, Reverse, Neutral, Drive) while holding the brake. This circulates the new fluid. 
• Check the level: Turn the engine off and check the fluid level with the dipstick. Add more fluid in small increments if the level is low, or drain a small amount if it's too high. 
• Re-check: Repeat the process of running the engine and checking the dipstick until the fluid level is correct according to the dipstick's hash marks for a "hot" reading. 

Important considerations

• A drain and fill is different from a full transmission flush, which requires significantly more fluid (10-12 quarts or more) because it aims to replace all the fluid, including what's in the torque converter. 
• You should always use the specific type of transmission fluid recommended by your vehicle's manufacturer to avoid damage. 
• Some vehicles, like certain Land Rovers, do not have a dipstick and require a fluid extractor to add new fluid. Consult your owner's manual to be certain.