How much weight can a 2010 Subaru Outback carry?
A 2010 Subaru Outback can carry roughly 800 to 1,000 pounds of payload, depending on the model and equipment. This payload includes passengers and cargo, and you should verify the exact figure on your vehicle’s door sticker.
Understanding what “payload” means for the Outback
Payload is the maximum weight the vehicle can carry beyond its own curb weight. It is calculated as the vehicle’s gross vehicle weight rating (GVWR) minus the curb weight. The GVWR is the limit set by the manufacturer for the total vehicle weight when fully loaded with people, cargo, and equipment. The curb weight is the weight of the vehicle with standard equipment and a full fuel tank, but no passengers or cargo. For an Outback, that payload range can vary by engine choice and trim level, so the exact number is on the door jamb placard on your specific vehicle.
Estimated payload ranges for common 2010 Outback configurations
Below are typical payload ranges you might encounter on 2010 Outback models. These figures can vary with options, tires, and equipment, so use the door sticker for a precise value.
- 2.5L four-cylinder (2.5i) models: approximately 900–1,000 pounds of payload
- 3.6L six-cylinder (3.6R) models: approximately 700–800 pounds of payload
- Automatic vs. manual transmissions: minor differences in curb weight can shift payload by a small margin
These ranges reflect typical configurations from the era. Real-world usable payload depends on the exact wheel/tire setup, optional equipment, and any added cargo or passengers beyond what the label anticipates.
Important caveats about carrying weight
Even when within payload limits, how weight is distributed matters for handling and safety. Overloading the rear or front in a way that unbalances the vehicle can affect braking, steering, and suspension performance. If you plan to tow, note that payload limits are separate from towing capacity, which has its own limits and hitch requirements. Always stay within the GVWR and observe manufacturer guidelines for hitch and towing weights.
How to check the exact payload for your 2010 Outback
To determine the precise payload for your specific vehicle, read the door jamb placard or consult the owner’s manual. The placard lists the GVWR, curb weight (often shown as “curb weight” or “unloaded weight”), and the corresponding payload calculation for that exact configuration. If you have a copy of the VIN and build sheet, you can also cross-check numbers with Subaru’s official data for that model year.
Summary
For a 2010 Subaru Outback, expect a practical payload in the neighborhood of 800–1,000 pounds for four-cylinder models and somewhat less for V6-equipped versions, with exact figures varying by trim and options. Always rely on the door jamb label for your vehicle’s precise GVWR, curb weight, and payload, and distribute weight evenly to maintain safe handling.
What is the carrying capacity of the Subaru Outback?
2021–2025 Subaru Outback (Same Measurements Across These Years) From 2021 through 2025, cargo room is consistent: 32.6 cubic feet behind the rear seats and 75.6 cubic feet with the second row folded.
How much weight can you put into a Subaru Outback?
I have an 2022 Outback XT Limited and based on the tag inside the driver door the Payload is 900 lb. However the Outback has a Gross Vehicle Weight Rating (GVWR) of 5026 lb and Curb Weight of 3933 lb, therefore the Payload should be 1093 lb based on GVWR - Curb Weight = Payload.
How much weight can a 2011 Subaru Outback carry?
Dimensions
| Wheelbase | 107.9 in. |
|---|---|
| Turning circle | 36.8 ft. |
| Ground clearance | 8.7 in. |
| Curb weight | 3,536 lbs. |
| Maximum towing capacity | 2,700 lbs. |
How much weight can a 2010 Subaru Outback tow?
Fourth-generation Outbacks follow the same general pattern: four-cylinder models (2.5i) are typically rated up to 2,700 pounds, and six-cylinder 3.6R models up to 3,000 pounds. Examples include 2014 3.6R (3,000 lbs) and 2012 2.5i (2,700 lbs), with 2010 3.6R also listed at 3,000 lbs.
