What is the correct tire pressure for a Honda HRV?

The correct tire pressure for a Honda HR-V is whatever the vehicle’s official specification prescribes for your exact year, trim, and tire size. In practice, many HR-Vs use about 32 psi (cold) per tire, but the precise number can vary. Always verify the exact value on the driver’s door jamb placard or in the owner’s manual.

Where to find the official specification for your HR-V

To ensure you inflate to the right number, start with your car’s official guidance. The following steps help you locate and confirm the exact tire pressure for your vehicle.

• Check the driver’s door jamb placard for the recommended cold tire pressure (front and rear) for your specific HR-V model and tire size.


• If the placard is missing or unreadable, consult the owner’s manual for the correct specification by year and trim.


• Be aware that some trims with different tires (for example, larger wheels or run-flat tires) may have a different value shown on the placard.


• Note that additional guidance may exist for heavily loaded conditions or for using a spare tire in daily driving; follow those instructions when applicable.

Bottom line: the exact number varies by year, trim, and tire size, so start with the placard or manual to get the precise value.

How to measure and maintain proper tire pressure

Once you know the target value, follow a careful process to measure and adjust tire pressure accurately. The steps below help ensure consistency and safety.

• Check tire pressure when the tires are cold (before driving more than a mile or two) to get an accurate reading.


• Use a reliable tire pressure gauge and inflate each tire to the exact cold-pressure specification shown on the placard or in the manual.


• Check all four tires, and don’t forget the spare if your vehicle is equipped for frequent use of a full-size tire.


• Recheck pressures after driving and the tires have warmed up, then adjust back to the specified cold pressure as needed once tires cool down again.

Maintaining the correct tire pressure supports optimal handling, tire wear, and fuel efficiency, so regular checks are part of routine vehicle maintenance.

Variations, seasonal considerations, and tips

Understand how conditions can affect tire pressure and what to do about it. Temperature and load are common factors that influence the numbers you should use.

• Cold weather tends to reduce tire pressure; you may need to add air to stay at the specified cold pressure when temperatures drop.


• Warm weather can raise tire pressure; avoid overinflation if you notice the tires appear firm after a period of hot driving.


• Always rely on the door placard as the primary source of the correct value; TPMS warnings should prompt you to check pressures if a tire is underinflated.


• If you’ve changed tire size (aftermarket wheels/tires), re-check the recommended pressure in the owner’s manual or with a Honda dealer, as the value may change with new tires.

In short, the official specification on the placard remains the authoritative target, with adjustments applied carefully for temperature, load, and tire size.

Special considerations for the Honda HR-V

Honda’s guidance for the HR-V emphasizes consistency with the manufacturer’s recommended values and regular checks. Drivers should:

• Adhere to the exact numbers shown on the placard for front and rear tires, which may be the same or slightly different depending on trim and tire setup.


• Consider seasonal checks as part of annual maintenance, especially when the vehicle carries heavier loads or uses different tires than those specified originally.


• Use the TPMS as an alert system, but do not rely on it exclusively; verify pressures with a gauge during routine checks.

These practices help ensure that your HR-V maintains balanced handling, even tire wear, and efficient fuel use across varying driving conditions.

Summary

The correct tire pressure for a Honda HR-V is the value listed on the driver’s door jamb placard for your exact year, trim, and tire size. While a common baseline is around 32 psi (cold) per tire, always verify the precise specification in the placard or the owner’s manual and adjust for load, temperature, and tire type. Regularly check all tires when cold, and use TPMS as a supplementary guide to maintain optimal performance and safety.

What is the correct tire pressure for a 2016 Honda HRV?

Honda Hr-V 2016 Tyre Pressure

Front Tyre Size	Front Tyre Pressure	Rear Tyre Pressure
215/60/R16 V 99	32 PSI / 2.2 BAR	30 PSI / 2.1 BAR

Should I use 32 or 35 tire pressure?

For most cars, the recommended tire pressure is between 32 and 35 psi, and you should use the pressure listed on the driver's side door jamb or in the owner's manual. The correct pressure can vary by vehicle, and the pressure on the tire's sidewall is a maximum, not the recommended value. Using the correct pressure ensures proper handling, fuel efficiency, and tire life, while using the wrong pressure can cause poor handling, reduced traction, and premature wear.
 
How to find the right pressure

• Check the sticker on the driver's side door jamb. This is the most reliable source for your specific vehicle. 
• Consult your owner's manual for the manufacturer's recommendation. 
• Note that the pressure should be checked when the tires are cold (before driving). 
• Don't use the pressure listed on the tire's sidewall, as this is the maximum pressure the tire can hold, not the recommended pressure for your car. 

Why the correct pressure is important

• Too low: Can lead to poor fuel economy, premature tire wear, and a higher risk of tire failure. 
• Too high: Can cause reduced traction, an uncomfortable ride, and rapid, uneven tire wear. 
• Correct pressure: Optimizes handling, safety, and fuel efficiency, and helps your tires last longer. 

What psi should my Honda tires be at?

The correct Honda tire pressure is on a sticker inside the driver's side doorjamb and is typically between 32 and 35 PSI for sedans like the Civic and Accord, while SUVs may require 35 PSI. Always check the pressure when the tires are cold and use a gauge to inflate to the manufacturer's recommended level found on the sticker. If the TPMS light is on, it could be due to a significant temperature change or a low tire, so check the pressure first.
 
Where to find the correct pressure

• Open the driver's door: A yellow and white sticker is located on the doorjamb with the recommended tire pressure for your specific model. 
• Consult your owner's manual: The manual also contains the correct information. 

How to check and inflate

1. Check when tires are cold: This provides the most accurate reading, as pressure increases with heat from driving. 
2. Use a tire pressure gauge: Press the gauge onto the valve stem to get a reading. 
3. Inflate to the recommended PSI: Add air slowly to avoid over-inflation. You can use an air compressor at a gas station or a portable one. 
4. Check all four tires: Make sure each tire meets the recommended pressure. 

Common pressure levels

• Sedans (Civic, Accord): Approximately 32-35 PSI.
• SUVs (Pilot, Passport): Approximately 35 PSI. 

What to do if the TPMS light is on

• Check your tire pressure first, as temperature changes can trigger the sensor. 
• If a tire is low, inflate it to the correct pressure. You may need to drive for a few minutes to reset the system. 
• If the light remains on, or if you suspect a leak, see a mechanic for a professional inspection. 
• If you've recently rotated your tires or had a tire replaced, you may need to recalibrate the TPMS system. Navigate to the "TPMS Calibration" option in your vehicle's settings menu to do this. 

What psi should my tires be on a Honda CR-V?

The recommended tire pressure for a Honda CR-V is typically 30-35 PSI, but the exact specification depends on the model year and trim. For precise information, check the sticker on the driver's side doorjamb or the owner's manual. It's crucial to check the pressure when the tires are cold.
 
This video shows how to check the tire pressure on a Honda CR-V: 53sHelpful DIYYouTube · Feb 10, 2024
How to find and set the correct tire pressure

1. Locate the information: The most accurate pressure for your specific vehicle is on a sticker inside the driver's side doorframe or in the owner's manual. 
2. Check the tires when cold: Measure the tire pressure when the tires haven't been driven recently. Driving heats the tires, which increases the pressure reading. 
3. Use a pressure gauge: Use a tire pressure gauge to check the pressure in each tire. A general range is between 30 and 35 PSI, but your vehicle may have a slightly different recommendation, such as 33 PSI for front tires and 30 PSI for rear tires for some models. 
4. Inflate as needed: Add or release air to meet the recommended pressure listed on your doorjamb sticker. 
5. Check the spare tire: Don't forget to check the pressure of your spare tire as well. 
6. Reset the TPMS light (if applicable): If the low tire pressure light is on, you may need to reset the system after inflating the tires. You can often do this by driving for a few minutes or by using a TPMS reset button located on the dashboard, as shown in this YouTube video. 

You can watch this video to learn how to reset the TPMS light on a Honda CR-V: 59sFixin ItYouTube · Dec 9, 2024