What is the torque on the brake calipers for a 2014 Dodge Ram?
The torque your Ram requires depends on which caliper you’re fastening and the exact model/trim. There isn’t a single universal number for all 2014 Ram trucks. In general, front caliper mounting bolts are torqued in a higher range than rear caliper bolts, but you should verify with the factory service manual for your specific vehicle.
Front brake calipers
When working on the front brakes, technicians rely on a specific torque range for the caliper-to-bracket mounting bolts. The following values represent typical ranges used on many 2014 Ram models; always confirm with the official service documentation for your exact truck.
- Front brake caliper mounting bolts (caliper-to-bracket): 75-110 Nm (55-81 ft-lb)
Concluding: Front caliper bolts must be tightened to the published spec using a calibrated torque wrench, then rechecked after a short test drive to ensure the caliper seats correctly against the rotor.
Rear brake calipers
Rear caliper torque specifications reflect the different hardware common to the rear braking system on many 2014 Ram variants. Use the manual specific to your VIN to confirm the exact figure for your truck; the ranges below are typical for rear caliper mounting.
- Rear brake caliper mounting bolts (caliper-to-bracket): 60-90 Nm (44-66 ft-lb)
Concluding: Like the front, rear caliper bolts should be torqued to spec with a proper wrench, and the installation should be checked after bed-in and road testing.
Important notes and best practices
These ranges cover standard caliper-to-bracket mounting bolts. Some Ram models or trims use different hardware or braking configurations (for example, some rear setups may differ between discs and drums or include parking brake components). Always cross-check with the official Mopar service information for your exact vehicle, and follow all factory-recommended procedures for thread cleanliness, lubrication (if specified), and torque sequencing.
How to apply and verify torque
1) Gather the correct tools: a calibrated torque wrench, appropriate sockets, and any torque angle adapters if your manual calls for angular tightening after initial torque. 2) Clean the bolt threads and seating surfaces. 3) Hand-tighten bolts, then torque to the specified value in a cross-pattern (if two bolts). 4) Re-torque after a short period or road test if required by the manual. 5) Inspect for caliper alignment and rotor run-out before completing the job.
Summary
For a 2014 Dodge Ram, front caliper mounting bolts are typically torqued in the range of 75-110 Nm (55-81 ft-lb), while rear caliper mounting bolts are typically torqued in the range of 60-90 Nm (44-66 ft-lb). These are general guidelines; the exact specification depends on the truck’s model, trim, and braking configuration. Always consult the official factory service manual or Mopar’s service information portal for the precise numbers for your vehicle, and torque to spec with a properly calibrated wrench.
