What is the width of the axle on a 1963 Ford Falcon?
The 1963 Ford Falcon had an axle width of 56 inches, or 4 feet 8 inches. This measurement refers to the distance between the outer ends of the axle, which is a crucial specification for the vehicle's handling and stability.
Understanding Axle Width
The axle width, also known as the track width, is the distance between the outer ends of the left and right axles on a vehicle. This measurement is an important factor in determining a car's stability, handling, and overall performance. A wider axle generally provides better stability and cornering ability, while a narrower axle can improve fuel efficiency and maneuverability.
The axle width on the 1963 Ford Falcon was a relatively standard measurement for a compact car of that era. This specification helped to give the Falcon a balanced and responsive driving experience, making it a popular choice among drivers who valued a combination of practicality and performance.
The 1963 Ford Falcon
The 1963 Ford Falcon was a compact car produced by the Ford Motor Company. It was the third generation of the Falcon model, which had been introduced in 1960 as a smaller, more fuel-efficient alternative to Ford's larger vehicles. The 1963 Falcon was available in a variety of body styles, including a two-door sedan, a four-door sedan, and a station wagon.
In addition to its 56-inch axle width, the 1963 Falcon was powered by a range of inline six-cylinder and V8 engines, depending on the model and trim level. The car's lightweight construction and responsive handling made it a popular choice among drivers who wanted a practical and affordable vehicle that was also fun to drive.
Conclusion
The 1963 Ford Falcon had an axle width of 56 inches, or 4 feet 8 inches, which was a standard measurement for a compact car of that era. This specification helped to give the Falcon a balanced and responsive driving experience, contributing to its popularity among drivers who valued a combination of practicality and performance.
What is a 1963 Ford Falcon worth?
The value of a 1963 Ford Falcon can vary greatly depending on its condition, mileage, options, and history. Typically, you can expect to pay around $9,891 for a 1963 Ford Falcon in good condition with average spec. The highest selling price of a 1963 Ford Falcon at auction over the last three years was $15,400.
What is axle dimensions?
Most thru-axles are described by four measurements, and you might see them described something like this: 15 x 100mm, 127 length, 1.5. In this example, 15mm is the diameter, 100mm is the O.L.D., 127mm is the overall length and 1.5mm is the thread pitch.
What is the width of the rear end of a 1964 Ford Falcon?
Here it is again,64/65 Comet/Falcon 8" rearend is 58 inches wide! You will need to narrow an 8.8 to fit,most people remove the long axle tube and axle and replace it with a second narrow side tube and axle!
How wide is a 1963 Ford Falcon?
Deluxe, 2.4L, Leaded Petrol, 3 SPEED MANUAL
| Dimension | Metric | Imperial |
|---|---|---|
| Ford Falcon Height | 1384 mm | 4 ft 6 in |
| Ford Falcon Width | 1778 mm | 5 ft 10 in |
| Ford Falcon Length | 4602 mm | 15 ft 1 in |
| Ford Falcon Wheelbase | 2781 mm | 9 ft 1 in |
What is the width of a 1963 Falcon rear axle?
A stock 63 falcon V8 is 56 inches, the narrowest 8" ford made. Approximate rear end widths measured from backing plate to backing plate.
How wide is a full width axle?
Full width refers to the width of axles out of a full size truck/van. You are correct they do vary quite a bit. Usually a full width is in the neighborhood of 67-69" WMS for front axles and 66-67" for the rear.
What is the width of a 1960 Falcon rear axle?
The 1963 Falcon and Comets Rear Axles as well as the 1960, 1961, 1962 7 1/4 Axels are suppose to be 55.8 Inch Wide.
How many Ford Falcons were made in 1963?
Ford made eight different models of the Ford Falcon in 1963 (not counting Mercury's sibling Comet) for a total production of 328,339 units. For the purposes of building a hot rod, however, the model that carries the highest value by far is the Ford Falcon Futura Sprint hardtop coupe, of which only 10,479 were built.
What is the width of a 1961 Ford Falcon rear axle?
The standard width is 56.5″ Axle Flange to Axle Flange but custom widths are available for mini-tubbed cars.
How wide is the rear axle on a 1965 Falcon?
The 1964 & 65 Falcon and Comets V8's had a 58 inch wide 8 inch axle. The match from that is the 1977 to 1981 Granada / Monarch had both the 8 and 9 inch axles or the Lincoln Versailles 9 inch rear end the bonus is that they also have Disk Brakes.
