What kind of oil does a 2017 Toyota IM take?
The short answer: the 2017 Toyota iM uses 0W-20 full-synthetic motor oil, about 4.7 quarts with the filter.
The iM (the hatchback formerly sold as the Scion iM, and later rebranded as the Corolla iM) relies on a 1.8-liter engine that demands modern, low-viscosity oil. The following guide outlines the official oil type, capacity, and maintenance guidance for this model.
Recommended oil specifications
Use this checklist to ensure you meet Toyota's specified oil standards for the iM.
- Oil grade and specification: 0W-20 synthetic motor oil (full synthetic preferred). Choose a brand that meets API SN or newer and ILSAC GF-5 or higher.
- Alternatives: If 0W-20 is not available, 5W-20 can be used temporarily but switch back to 0W-20 at the next oil change per the manual.
- Capacity: Approximately 4.7 quarts (4.4 liters) of oil when changing the filter; exact capacity can vary by market, so consult the manual or dipstick after filling.
- Fill and checks: Replace the oil filter, fill to the correct level, and recheck with the dipstick after the engine has cooled for a few minutes.
Bottom line: Use 0W-20 synthetic oil that meets API SN and ILSAC GF-5 or higher, with about 4.7 quarts of oil on a typical change.
Oil capacity and maintenance intervals
Before detailing numbers, here are the practical oil capacity and service intervals for the iM.
- Oil capacity: Approximately 4.7 quarts (4.4 liters) with the filter; this figure can vary slightly by market or trim, so verify on the under-hood sticker or in the manual.
- Change interval: With full-synthetic 0W-20, Toyota typically recommends about every 10,000 miles (16,000 km) or 12 months, whichever comes first, though severe driving conditions may require more frequent changes.
- Filter replacement: Replace the oil filter with every oil change to maintain filtration efficiency.
- Monitoring: Rely on the vehicle’s Oil Life Monitor and your driving conditions to determine actual intervals; service when the monitor indicates.
For the most accurate guidance, consult the owner’s manual specific to your vehicle and region, as specifications can vary by market and trim.
Summary
The 2017 Toyota iM uses 0W-20 full-synthetic motor oil, approximately 4.7 quarts with the filter. Use API SN or newer and ILSAC GF-5 or higher. Change every about 10,000 miles (12 months) under normal conditions with synthetic oil, and follow the Oil Life Monitor for precise intervals. Always verify exact figures in your owner's manual or on the vehicle sticker for your specific market and trim.
How many quarts of oil are in a 2017 Toyota Corolla iM?
4.4 quarts
A 2017 Toyota Corolla iM takes 4.4 quarts of oil.
What kind of oil does a 2017 Toyota take?
The recommended oil for a 2017 Toyota is 0W-20 full synthetic motor oil for most models, including the Corolla. If 0W-20 is unavailable, 5W-20 can be used temporarily but must be replaced with 0W-20 at the next oil change. Always check your owner's manual for the specific requirements of your vehicle.
2017 Toyota oil type details
- Recommended oil: 0W-20 full synthetic
- Alternative if 0W-20 is unavailable: 5W-20 (use temporarily, switch to 0W-20 at the next oil change)
- Reason for recommendation: This grade of oil is recommended for better fuel economy and cold-weather performance.
- Important: It is crucial to verify the correct oil type in your vehicle's owner's manual, as requirements can vary by specific model and engine.
What kind of oil for 2017 Toyota Corolla iM?
What is the Recommended Oil Type for the Toyota Corolla? For Toyota Corolla models made in 2009 or later, Toyota recommends using 0W-20 synthetic motor oil. Meanwhile, Corolla models made in 2008 or earlier should use 5W-30 synthetic motor oil.
Can I use 0w20 instead of 0w16 corolla?
Yes, you can use 0W-20 instead of 0W-16, as most owner's manuals state that 0W-20 is an acceptable substitute if 0W-16 is not available. However, for optimal fuel efficiency and engine wear, the owner's manual recommends replacing it with 0W-16 at the next oil change. Using 0W-20 may result in a slight decrease in fuel economy, and if your car is still under warranty, it's best to follow the manual's instructions to avoid any potential issues.
Important considerations
- Warranty: If your car is still under warranty, using 0W-20 is acceptable for a single oil change, but you should switch back to the recommended 0W-16 for the next one to avoid any potential warranty issues.
- Fuel economy: Switching to 0W-20 may lead to a slight decrease in fuel economy, though some drivers report it runs well and is slightly quieter.
- Engine performance: For most driving conditions, the difference between 0W-16 and 0W-20 is minimal, and your engine will likely run well with 0W-20. However, 0W-16 is specifically designed for better fuel efficiency and reduced engine warm-up time, so it is the optimal choice if available.
- Availability: 0W-16 is a newer, less common oil, so 0W-20 is a good alternative when 0W-16 is hard to find.
- Engine wear: Some users report that a thicker oil like 0W-20 may offer better lubrication and temperature control, especially in spirited driving, while others believe that the slight increase in wear is negligible, particularly for newer engines.
