What transmission fluid does a 2005 Dodge Dakota take?
The 2005 Dodge Dakota requires Mopar ATF+4 automatic transmission fluid. This is a specific type of fluid designed for use in Chrysler, Dodge, and Jeep vehicles with automatic transmissions. The recommended fluid capacity for the 2005 Dakota is approximately 12 quarts.
Transmission Fluid Details
The 2005 Dodge Dakota was available with either a 4-speed automatic or 6-speed manual transmission. The automatic transmission requires the use of Mopar ATF+4 fluid, which is a synthetic blend transmission fluid. This fluid is engineered to provide optimal lubrication, wear protection, and performance in Chrysler automatic transmissions.
The recommended fluid capacity for the 2005 Dakota's 4-speed automatic transmission is approximately 12 quarts. It's important to use the exact specified fluid type and to change the transmission fluid at the recommended service intervals to ensure the transmission operates properly and has a long service life.
Transmission Fluid Change Procedure
- Park the vehicle on a level surface and apply the parking brake.
- Locate the transmission fluid drain plug, usually on the bottom of the transmission case.
- Place a drain pan underneath and remove the drain plug to allow the old fluid to drain out.
- Once the fluid has fully drained, replace the drain plug and tighten it securely.
- Locate the transmission fluid fill plug, usually on the side of the transmission case.
- Slowly pour in new Mopar ATF+4 fluid through the fill plug until it begins to drip out.
- Replace the fill plug and tighten it securely.
- Start the engine and let it idle for a few minutes to circulate the new fluid.
- Check the fluid level and add more if necessary to bring it up to the proper level.
It's recommended to change the transmission fluid in the 2005 Dodge Dakota every 30,000 miles or as specified in the owner's manual to maintain optimal transmission performance and longevity.
Does it matter what transmission fluid I use?
Choosing the correct transmission fluid is critical to insuring the maximum performance and fuel economy from your car.
How much transmission fluid does a 2005 Dodge Dakota 4.7 L take?
Automatic Transmission Fluid
Capacity: 5.5 quarts Initial Fill.
What transmission does a 4.7 Dodge Dakota have?
Third generation (2005–2011)
| Third generation | |
|---|---|
| Engine | 3.7 L (226 cu in) PowerTech V6 4.7 L (287 cu in) PowerTech V8 |
| Transmission | 4-speed 42RLE automatic 5-speed 545RFE automatic 6-speed Getrag 238 manual |
| Dimensions | |
| Wheelbase | 131.3 in (3,335 mm) |
What transmission fluid does a 2005 Dodge Dakota use?
Valvoline – MaxLife Multi-Vehicle (ATF) Full Synthetic Automatic Transmission Fluid, 1 Gallon (Part No. 773775)
How many quarts of transmission fluid does a Dodge Dakota take?
Remember when you change the fluid and the filters you are only losing approximately 6.5 quarts of fluid, the trans itself holds 14 quarts most of which is in the torque converter and pump, you should not have a problem with losing prime.
Does it matter what type of ATF you put in your transmission?
Always check your owner's manual for the type of fluid recommended for your vehicle by the manufacturer. Most, but not all, transmission fluids are blended with synthetic base oils to offer better performance, with improved resistance to heat, cold, oxidation, friction, and shearing.
What transmission is in a 2005 Dodge Dakota?
The transmission in your Dakota is likely the 545RFE.
What brand of transmission does Dodge use?
Designed to handle Dodge's powerful engines, Allison transmissions bring exceptional reliability and durability. They're perfect for heavy-duty applications, such as commercial use, off-roading, or heavy towing. Enhance your Dodge Ram's towing abilities with an Allison 1000 transmission.
How many quarts does a 4.7 Dodge Dakota take?
6 quarts
Capacity: 6 quarts (with filter). After refill check oil level.
What kind of ATF does Dodge use?
This correct Dodge Charger transmission fluid can be identified as ZF 8 & 9 Speed ATF Automatic Transmission Fluid or equivalent, also known as Chrysler Mopar ATF part numbers 68218925AA, 68218925AB, 68339073AA, 668157995AA, or 68157995AB OEM part numbers.
