Where is the TPMS reset button on a Dodge Caliber?
The Dodge Caliber generally does not have a dedicated TPMS reset button. The system usually relearns automatically after you inflate the tires to the correct pressures and drive the vehicle; if needed, a dealer or tire shop can perform a manual relearn with specialized equipment.
How TPMS works in the Caliber
The Tire Pressure Monitoring System (TPMS) uses sensors in each tire to monitor air pressure and report the readings to the vehicle’s computer. If a tire is underinflated or a sensor fails, the warning light on the dash illuminates. On the Caliber, there is no user-activated reset switch in most trims—the system is designed to relearn as you drive once proper pressures are restored.
Resetting the TPMS on a Dodge Caliber
To guide you through the standard relearn process, follow these steps:
- Inflate all tires to the recommended cold pressures specified on the door jamb sticker or in the owner's manual. Ensure the vehicle is cold when you check pressures.
- Drive on a clear highway at a steady speed of about 50 mph (80 km/h) or higher for roughly 10 minutes to allow the TPMS to relearn the tire sensor IDs.
- If the warning light remains on after correct inflation and driving, recheck all pressures. If they are correct and the light still stays on, the system may require a manual relearn with a diagnostic tool or sensor service at a tire shop or dealership.
Concluding note: In most Dodge Caliber configurations, this automatic relearn is sufficient. If a sensor is faulty or damaged, professional service may be required to restore proper TPMS operation.
When to seek professional help
If the TPMS warning persists after confirming proper tire pressures and completing a highway relearn, schedule a visit to a tire shop or dealership. They can perform a manual relearn with a TPMS tool, diagnose sensor failures, and replace faulty sensors as needed.
Summary
For the Dodge Caliber, there is typically no physical TPMS reset button to press. Correct tire inflation and a highway drive usually retrain the system. If the warning light remains, a technician can perform a manual relearn or diagnose sensor issues to restore accurate monitoring.
Where is my TPMS reset button located?
Process will begin if there's no button the procedure is done with the display audio. Begin by pressing the home. Button then touch settings touch vehicle next and then TPMS calibration.
How do you reset the TPMS sensor on a Autozone?
Reset the tire pressure light by inflating all tires to the recommended pressure, then use the TPMS reset button, a scan tool, or drive for 10 to 30 minutes to recalibrate.
How do you reset the TPMS on a Dodge Caliber?
With the vehicle off, turn the key to the “On” position, but don't start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh.
How to reset tire pressure sensor dodge challenger?
On turn the climate controls navigation system off to limit the battery drain. Often it helps to activate the sensors before the drive. So during the 20 minutes we're going to scan each sensor.
