Wheres the starter in a 2007 Acura MDX?
The starter on a 2007 Acura MDX is mounted to the lower front portion of the engine block near the bellhousing on the passenger side, and it is typically accessible from underneath the vehicle. This location is common for the MDX’s transverse V6 layout and is the starting point for inspection or replacement.
In this model year, the MDX uses a 3.5-liter i-VTEC V6 engine. The starter’s job is to engage the engine’s flywheel or flexplate to crank the engine when you turn the key or press the start button. Knowing its general spot helps with diagnosis if you’re dealing with a no-start condition or planning a service procedure.
Where the starter sits in the MDX engine bay
The starter sits low in the engine bay, near the point where the engine meets the transmission (the bellhousing). In the MDX’s transverse layout, you’ll typically find it on the passenger side of the engine compartment, close to the bottom of the engine block and near the front subframe. Access is often easier from underneath the vehicle, sometimes with the front splash shield removed to reveal the starter and its wiring.
Here are the key cues to help you spot the starter quickly in the MDX’s engine bay:
- Mounted to the engine block, adjacent to the bellhousing where the transmission attaches.
- Located toward the passenger side of the engine bay and kept low in the frame area.
- Connected to the battery wiring and ignition circuit, with a thick positive cable and a solenoid mounted on the starter body.
With these cues, you can locate the starter for inspection or replacement. Always ensure the negative battery cable is disconnected and follow proper safety procedures before touching electrical components.
Variant notes and safety reminders
Variations can exist between production runs, but the starter in the 2007 MDX generally follows the described location. If you’re unsure, consult the factory service manual for your exact VIN or have a professional mechanic verify before attempting work.
Summary
The starter on a 2007 Acura MDX is mounted to the lower front portion of the engine block near the bellhousing on the passenger side, usually accessible from underneath the vehicle. This familiar spot, combined with the engine’s transverse layout, helps drivers and technicians locate and service the starter when diagnosing starting issues or performing a replacement.
How much does it cost to replace the starter on a Acura MDX?
The cost to replace an Acura MDX starter typically ranges from $600 to over $2,400, depending on the model year and parts. For a more recent model like a 2018, the total cost can be between $1,541 and $2,379, while an older 2002 model might cost $616 to $898. The price depends on parts, labor, and the specific vehicle.
Cost breakdown
- Parts: The starter part itself can cost anywhere from about $150 to over $400, with remanufactured options often being cheaper than brand-new ones.
- Labor: Labor costs can vary based on the complexity of the replacement, which depends on the car's year and model.
- Price variations: Costs can vary significantly. For example, a 2018 Acura MDX replacement might cost between $1,541 and $2,379, while a 2002 model could be between $616 and $898.
How to get a more accurate estimate
- Provide your vehicle information: Use online estimators from sites like YourMechanic or Kelley Blue Book and input your specific Acura MDX's year to see a more accurate estimate for your local area.
- Contact a local mechanic: Call a few local auto shops or dealerships for a quote based on your vehicle's specific make and model.
Why is my 2007 Acura MDX not starting?
When the 2007 MDX's console lights up but won't start, first test the battery voltage and connections. A weak or dead battery often causes this symptom. Next, inspect the ignition switch and starter relay for faults. Corroded terminals or a failing starter motor can also prevent engine cranking.
How much is a starter for a 2007 Acura MDX?
The average price for Starter Parts for the 2007 Acura MDX is $193.99.
Where is the starter located?
The starter is located where the engine and transmission meet, near the flywheel or flex plate. Its exact position varies, but it's usually under the engine, often accessible from the bottom of the vehicle. To find it, you can look between the engine and transmission, and a helpful trick is to follow the main red cable from the positive terminal of the battery, as it leads directly to the starter.
This video shows the location of the starter on a vehicle: 46sChrisFixYouTube · Jan 13, 2017
Common locations and how to find it
- Between engine and transmission: The starter is mounted to the engine block and connects to the transmission bell housing.
- Under the engine: For most front-wheel drive vehicles, you can find it under the engine on the driver's side.
- Near the flywheel: It is always situated close to the engine's flywheel or the flex plate.
- Follow the battery cable: Trace the thick red cable that runs from the positive battery terminal; it will lead you straight to the starter.
- Check under the vehicle: You will likely need to get under the car to see it, possibly by raising it with a jack and using jack stands for safety.
You can watch this video to learn how to locate the starter by following the battery cable: 39sSell Those Flipping CarsYouTube · Sep 3, 2025
