How do you turn off the change filter light on a HRV?
The change filter light on a residential HRV is a maintenance reminder that typically goes off after you replace the filter and reset the indicator. The exact reset method varies by model, but the general approach is the same: replace the filter, then trigger a reset on the controller or unit.
Understanding what triggers the light
The light signals that the air filter is dirty or nearing the end of its service life. Some systems use a timer-based reminder in addition to sensor data. After you replace the filter, resetting the indicator is what clears the light and returns the unit to normal operation. Always consult your manual for model-specific meanings and intervals.
Steps to turn off the change filter light after replacing the filter
Below is a general procedure that covers common reset methods used by many HRVs. If your model has a different button layout or screen flow, refer to the manual or manufacturer support for exact steps.
- Power off safety: Switch off the HRV at the breaker or unplug it to ensure safe maintenance.
- Access and replace the filter: Open the access panel, remove the old filter, clean the housing if needed, and install a new filter of the correct type and size. Re-seal the housing.
- Return power and prepare the unit: Restore power and ensure the system is ready to accept a reset (some models require a brief run cycle or waiting a few seconds).
- Reset the change-filter indicator: Use the reset method that matches your model. Common options include:
- Controller reset: On many controllers, press and hold the Reset button for 3–10 seconds, or navigate to a "Reset Filter" option in the menu and confirm.
- Manual reset on the unit: Some air handlers have a small recessed reset button; depress and hold it for several seconds with a pointed object.
- Power-cycle reset: In some cases, turning the power off for about 30 seconds and then back on will reset the indicator.
- Verify operation: After resetting, the light should go off. If it reappears, double-check the filter seating and compatibility, or consult the manual for troubleshooting.
With the light reset, monitor the system for proper operation. If the indicator returns, there may be a sensor issue or a need for another filter replacement sooner than expected.
Model-specific considerations
Some common brands include Panasonic, Broan, Venmar, and S&P, but reset procedures differ by model. Always consult the user manual for your exact model number or visit the manufacturer’s website for model-specific instructions and support.
Summary
Turning off the change filter light on an HRV generally involves replacing the dirty filter and performing the model-specific reset—usually by holding a reset button on the controller or unit, or by a brief power cycle. If the light persists, refer to the manual or contact a professional. Regular maintenance helps keep ventilation efficient and indoor air quality high.
How do I turn off the clean filter light on my air conditioner?
And the light for check filter might be on so after you clean your filter all you do you're going to press right here where it says check filter you want to press and the light is going to be gone.
How do you reset the filter light after changing the filter?
That's the beep and it resets the water filter. Light here is a side by side. And this is the filter reset button right here again hold the button for 3 seconds.
How do you reset the filter warning on HRV?
To reset the filter light on an HRV AirSense system, you'll need to navigate through the menu, select "About your HRV," tap the screen three times, then choose "Install 3" and finally, select "Filter Reset".
How to reset filter light on air filter?
Find the Reset Button on the Filter: The filter reset button is located on the head control panel and can be referred to as "Filter Reset" or "Reset." Hold Down the Reset Button: Once again, press the reset button and hold it for a couple of seconds until the filter light goes off.
