How many litres of transmission fluid does a Dodge Journey take?
Typically about 6.6 liters for a standard pan-drop service, and around 8.5–10 liters if you replace or flush the entire transmission.
The Dodge Journey used several variants of a four‑speed automatic across its production run, with small differences in capacity between the 2.4L four‑cylinder and the 3.5L V6. Exact fluid volume depends on the transmission type, whether you’re doing a simple drain-and-fill or a full system flush, and whether you’re including the torque converter and cooler lines. Always verify the precise figure for your VIN from the owner's manual or a dealer service bulletin.
Typical capacities by service type
To help you plan, here are common ranges you’ll encounter when servicing the Journey’s automatic transmission. The figures are given in liters.
- Drain-and-fill (pan drop with filter change): about 4.7–6.6 L
- Full replacement/flush (including cooler lines and torque converter): about 8.5–10.4 L
These ranges reflect the common setups found on Dodge Journeys equipped with the 4-speed automatic transmissions used in most model years. Your exact total may differ slightly based on year, engine, and whether you replace the fluid in the torque converter.
What affects the exact capacity?
Several factors influence the precise amount you’ll need for a given Journey. Understanding these can help you plan and avoid running low during service.
- Engine variant (2.4L vs 3.5L) and corresponding transmission pairing
- Whether you perform a pan drop only or a full flush with lines and torque converter
- Whether the service includes a new filter and pan gasket
- Model year and the specific transmission designation (these can change capacity slightly)
In practice, always confirm with the official service data for your VIN and follow the recommended procedure and fluid specification. Using the correct ATF type (as specified by Chrysler/Mopar for your year) is essential for proper operation and longevity.
Notes on fluid type and procedure
Most Dodge Journeys with the 4-speed auto use a Mopar automatic transmission fluid specification (ATF+4) or the equivalent recommended by the manufacturer for that year. Some later Chrysler transmissions may call for Dexron VI variants; always use the fluid specified for your VIN. When performing a refill, warm the engine, check the level with the vehicle on a level surface, and follow the manufacturer’s procedure for adding fluid gradually to avoid overfilling.
How to verify the exact capacity for your Journey
For precise figures tailored to your vehicle, take these steps. Look up your VIN in the official service data, check your owner's manual, or ask a Dodge/Chrysler dealer or certified shop. They can provide the exact capacity for your transmission variant and confirm the correct fluid specification.
Summary
For most Dodge Journeys with the common 4-speed automatic, plan on about 6.6 liters for a basic pan-drop service and roughly 8.5–10 liters for a full transmission replacement or flush. The exact total depends on model year, engine specification, and the service performed. Always verify with VIN-specific manuals or a dealer before beginning work.
How much transmission fluid does a Dodge Journey take?
Automatic Transmission Fluid
4 speed 40TES Total Fill 9.2 quarts.
What kind of transmission fluid for a Dodge Journey?
FRAM – ATF+4 Automatic Transmission Fluid: 1 Quart (Part No.
How many litres of transmission fluid is needed?
Depending on your car's make and model, how much transmission fluid you need will vary between 2.5 to 5.5 litres. Always check your car owner's manual for the exact amount required, or ask the friendly mechanics at mycar to steer you in the right direction.
How many quarts does a Dodge Journey 3.6 take?
5.9 quarts (with filter).
