How many quarts of oil does a 2006 Subaru Tribeca take?
The 2006 Subaru Tribeca, powered by a 3.0-liter flat-six, typically requires about 5.5 quarts of engine oil (with a new filter) for a full oil change.
The Tribeca (B9) launched in 2006 with Subaru’s EZ30 3.0-liter H6 engine. The standard capacity for a complete oil change that includes replacing the oil filter is about 5.5 quarts (roughly 5.2 liters). Real-world numbers can vary slightly based on filter size, drain completeness, and market specifications, so it’s best to confirm with the dipstick after refilling.
Engine details and oil capacity
The Tribeca’s oil-fill requirement centers on the 3.0-liter H6 EZ30 engine. For a legitimate full-change with a new filter, the commonly cited capacity is 5.5 quarts (5.2 liters).
Key numbers and notes to guide your oil fill are summarized below:
- Engine: 3.0-liter H6 (EZ30)
- Oil capacity with filter: 5.5 quarts (5.2 L)
- Possible variation: Some sources list 5.7–6.0 quarts depending on filter size and drain procedure
- Recommended oil: 5W-30 (synthetic or conventional) per the owner's manual; always use a new oil filter
In short, plan to add about 5.5 quarts of oil during an oil change with a new filter, and then top up as needed after checking the dipstick.
Dipstick check and top-up steps
- Warm up the engine, turn it off, and let the oil settle for a few minutes.
- Remove the dipstick, wipe it clean, reinsert fully, then pull it out to check the level.
- If the level is below the Full line, add oil in small increments (about 0.25 quart at a time), rechecking with the dipstick after each addition.
- Repeat until the level sits between the Low and Full marks, then run the engine again and recheck after a few minutes.
Having the engine warm and rechecking after a short idle helps ensure an accurate reading and avoids overfilling.
Additional notes
While 5.5 quarts is the standard for a 2006 Tribeca with the 3.0L H6, variations can occur due to regional specifications or changes in filters. Always consult the owner’s manual for VIN-specific guidance and use the dipstick as the final reference.
Summary
For a 2006 Subaru Tribeca equipped with the 3.0-liter H6, plan to fill with about 5.5 quarts of oil during a full change with a new filter, then verify and top up to the correct level using the dipstick. If you’re using a different engine variant or a non-standard filter, adjust accordingly and refer to the manual for exact specifications.
How much oil does a Subaru Tribeca 3.6 take?
6.9 quarts (with filter).
How many quarts of oil does a 3.0 L V6 take?
A 3.0L V6 engine typically takes between 4.5 and 6.5 quarts of oil, but the exact amount depends on the specific vehicle make and model. For example, a 2006 Ford Fusion 3.0L V6 requires 6 quarts, while a 2001 Jaguar S-Type 3.0L V6 needs 6.5 quarts. Always check your vehicle's owner's manual for the precise capacity and oil viscosity requirements.
| Vehicle | Oil Capacity |
|---|---|
| 2012 Ford Escape 3.0L V6 | 6 quarts |
| 2006 Ford Fusion 3.0L V6 | 6 quarts |
| 2003 Ford Ranger 3.0L V6 | 4.5 quarts |
| 2001 Jaguar S-Type 3.0L V6 | 6.5 quarts |
(this||self).Wufxzb=function(c,e,f,l,k){var d=document.getElementById(c);if(d&&(d.offsetWidth!==0||d.offsetHeight!==0)){c=d.querySelector("div");var g=c.scrollWidth-c.offsetWidth,h=Math.min(e?g:0,g);c.scrollLeft=e&&(l||f)?0:h;var a=d.getElementsByTagName("g-left-button")[0],b=d.getElementsByTagName("g-right-button")[0];a&&b&&(e=RegExp("\\btHT0l\\b"),f=RegExp("\\bpQXcHc\\b"),a.className=a.className.replace(e,""),b.className=b.className.replace(e,""),h===0?a.className="pQXcHc "+a.className:(a.className=
a.className.replace(f,""),k&&c.classList.add("pA30Ne")),h===g?b.className="pQXcHc "+b.className:(b.className=b.className.replace(f,""),k&&c.classList.add("FpCCub")),setTimeout(function(){a.className+=" tHT0l";b.className+=" tHT0l"},50))}};}).call(this);(function(){var id='_q9IlafyYKMWhi-gP97W5aA_159';var rtl=false;var gecko=false;var edge=false;var soh=false;
(this||self).Wufxzb(id,rtl,gecko,edge,soh);})();
How much oil do you put in a 3.6 L V6?
The oil capacity for a 3.6L V6 engine is typically 5 to 6 quarts, but it varies by vehicle model and year. For a 2020 Dodge Charger, it's around 5.9 quarts, while a 2023 Jeep Wrangler requires 5 quarts. Newer Jeeps, such as the 2016-2021 Grand Cherokee and Durango, often require 6 quarts. Always check your specific owner's manual for the most accurate information, as it can differ even within the same engine family.
- 5 quarts: Common in many models like the 2020 Jeep Wrangler and 2025 Ram 1500.
- 5.9 quarts: The capacity for some models, such as the 2020 Dodge Charger.
- 6 quarts: Required for certain vehicles, including the 2013 JK Jeep Wrangler and some 2016-2021 Grand Cherokee and Durango models.
- Check your owner's manual: This is the most reliable source for your specific vehicle's oil capacity.
- After refilling: It's important to check the oil level with the dipstick after refilling to ensure it is correct.
How much oil does a 2006 Subaru Tribeca take?
Oil Grade: SM
| Viscosity: | 10W-30, 10W-40 (Above -20°C) 5W-30 (All TEMPS) - SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 6 quarts (with filter). After refill check oil level. |
| Torque: | 33 ft/lbs (Oil Drain Plug) |
