Loading

How many quarts of oil does a 2JZ take?

Typically about 7 quarts of engine oil are needed for a full oil change with a new filter, but the exact amount depends on the 2JZ variant and any added equipment like an oil cooler. Planning with a small buffer is wise.


The 2JZ family includes two main variants used in Toyota performance cars: the turbocharged 2JZ-GTE and the naturally aspirated 2JZ-GE. Each version has its own baseline capacity, and additional hardware or pan designs can shift the total slightly. Below is a practical breakdown to guide servicing and topping off.


Typical capacities by variant


These figures assume a standard oil change with a new filter and no unusual modifications. If your car has an oil cooler, aftermarket pans, or different filter choices, expect a small variation.



  • 2JZ-GTE (turbo): Approximately 7.5 quarts (7.1 liters) with filter.

  • 2JZ-GE (naturally aspirated): Approximately 6.9 quarts (6.5 liters) with filter.


Note: Use the dipstick to verify the level after the engine has warmed up and settled, and adjust if necessary.


Factors that can affect the exact fill


Several variables can shift the final amount you’ll pour into the engine. Here are the key considerations to keep in mind when planning an oil change.



  • Oil cooler installation: A cooler or additional plumbing can add roughly 0.5 to 1 quart to the total capacity.

  • Oil pan variation: Deeper or shallower pans change the volume subtly.

  • Filter size and type: Different filters may alter the amount of oil needed to reach the full mark by a small margin.

  • Drain and fill procedure: Always drain fully, replace the filter with a new seal, add oil gradually, run the engine briefly, and recheck the level.


In practice, the cited figures provide a solid baseline. Always confirm exact capacity for your model year and configuration using the official manual or service guide, and verify with a dipstick after running the engine.


How to perform an oil change on a 2JZ: quick guide


Basic steps to ensure you use the right amount and reach the correct level:



  • Confirm the correct oil capacity for your specific variant and configuration (GTE vs GE, oil cooler, pan type).

  • Drain old oil completely, replace the drain plug, and install a new filter with a proper seal.

  • Add oil in stages, starting with the lower end of the expected range; start the engine and check for leaks.

  • Turn off the engine, wait for the oil to settle, and use the dipstick to top up to the full mark when the engine is warm.


Tip: After a warm-up, recheck the level and adjust to the full line on the dipstick if needed. Temperature and engine condition can influence the reading, so aim for the correct mark when the engine is at operating temperature.


Summary


The 2JZ engine family generally requires about 7 quarts of oil with a new filter, with the turbocharged 2JZ-GTE typically around 7.5 quarts and the naturally aspirated 2JZ-GE around 6.9 quarts. Exact capacity depends on variant and equipment such as an oil cooler or different filter/pan configurations. Always verify the precise specification for your model year in the official manual and confirm the final level with the dipstick after a warm-up.

How much oil does a 2JZ take?


Oil Grade: SL

Viscosity:10W-30 (Above -18°C) 5W-30 (Below 10°C)
Capacity:5.2 quarts (with filter). After refill check oil level.
Torque:33 ft/lbs (Oil Drain Plug)



How many Litres is a 2JZ engine?


A 2JZ is a 3.0-liter engine. Its full displacement is 2,9972 comma 9972,997 cubic centimeters, which is commonly rounded to 3.03.03.0 liters.
 

  • Displacement: 3.03.03.0 liters ($2,997$cc). 
  • Engine family: The 2JZ is part of Toyota's JZ engine family and is a larger version of the 2.5-liter 1JZ engine. 



How much oil does a 2.3 liter engine take?


6.2 quarts
Engine Oil
Capacity: 6.2 quarts (with filter).



How much oil does a 3.0 liter engine hold?


For most vehicles made between 2014 and 2019, the oil capacity is 10.5 quarts, while those made after 2020 have an 8.5-quart EcoDiesel oil capacity. The oil capacity will change slightly if you change the filter as well.


Kevin's Auto

Kevin Bennett

Company Owner

Kevin Bennet is the founder and owner of Kevin's Autos, a leading automotive service provider in Australia. With a deep commitment to customer satisfaction and years of industry expertise, Kevin uses his blog to answer the most common questions posed by his customers. From maintenance tips to troubleshooting advice, Kevin's articles are designed to empower drivers with the knowledge they need to keep their vehicles running smoothly and safely.