How many quarts of oil does an Acura take?
There isn’t a single number that fits every Acura. Oil capacity depends on the model, year, and engine. In general, most Acura four-cylinder engines take about 4.5 to 4.8 quarts of oil with a filter, while V6 engines typically require about 5.0 to 5.5 quarts. Turbocharged versions tend to fall in a similar to slightly higher range. For the exact figure, always check the owner's manual or the under-hood oil-cap information for your specific car.
What affects oil capacity?
Oil capacity is determined by engine design, displacement, and whether the capacity figure includes the oil filter. Year-to-year changes, different trims, and updated engines can shift the exact number. To avoid guesswork, use the official specification for your exact vehicle year and model.
Oil capacity by engine family
Four-cylinder engines
Most Acura four-cylinder engines fall in a narrow range. The following figures assume the oil filter is installed, which is standard practice for capacities quoted by manufacturers.
- Approximately 4.5–4.8 quarts of oil (with filter) for common 2.0L/2.4L i4 engines in models like ILX, TLX, and RDX variants.
- Typical maintenance references place the refill amount near 4.5–4.9 quarts when performing a full drain-and-fill.
Understanding these numbers helps when planning a routine oil change, but the precise amount can vary by year and exact engine within the family.
V6 engines
Acura’s V6 configurations (such as the 3.5L used in MDX, RLX, and older TLX variants) generally require a larger oil fill than four-cylinders.
- Approximately 5.0–5.5 quarts of oil (with filter) for typical 3.5L V6 engines.
- Some early or special versions may differ by a quarter-quart to a half-quart, so verify for your exact year.
As with four-cylinders, the best practice is to confirm the specific capacity for your model/year to ensure a proper oil level.
Turbocharged engines
Turbocharged four- and six-cylinder engines in recent Acura models tend to sit between the four-cylinder and V6 ranges, with slight variations by design and year.
- Typically about 4.5–5.0 quarts of oil (with filter) for turbocharged 2.0L or similar setups in RDX and TLX.
- Higher-performance turbo variants or different years may approach the upper end of this band.
Always cross-check your exact engine code and model year to be certain, since turbo designs can shift capacity slightly across generations.
Finding the exact specification for your Acura
When accuracy matters, the fastest route is to verify against official sources and your vehicle’s paperwork. The following steps help you determine the precise oil capacity for your car.
- Consult the owner’s manual for your model year and trim to find the official oil capacity (with filter) listed for your engine.
- Look at the under-hood oil-cap label, which often states the recommended oil capacity and grade for that specific engine.
- Check the vehicle identification details (VIN) or engine code if needed, and cross-reference with Acura’s official service portal or a trusted dealership resource.
- Verify whether your reference specifies with or without the oil filter; most manufacturer capacities refer to “with filter.”
- If in doubt, contact an authorized Acura service center for confirmation before draining or refilling oil.
Knowing the exact capacity for your car helps ensure you use the correct amount of oil during maintenance, preserving engine cleanliness and performance.
Summary
In short, Acura oil capacity isn’t a one-size-fits-all figure. Four-cylinder models typically require about 4.5–4.8 quarts, V6 variants about 5.0–5.5 quarts, and turbocharged versions generally land in a similar 4.5–5.0 quart range. Always verify with the specific manual or label for your year and engine to ensure an accurate fill.
How many quarts of oil does a 3.7 L V6 engine take?
6.0 qt
Capacities and Specifications - 3.7L
| Item | Capacity |
|---|---|
| Engine oil | 6.0 qt (5.7 L) |
| Engine coolant | 13.2 qt (12.5 L) |
| Brake fluid | Between MIN/MAX on brake fluid reservoir |
| Rear differential fluid (All Wheel Drive) | 2.4 pt (1.15) |
How many quarts of oil for a 3.5 l V6?
6 quarts
6 quarts (with filter). After refill check oil level.
How many quarts of oil for a 2015 Acura MDX?
The 2015 Acura MDX has an engine oil capacity of 5.7 quarts with a filter change. You should always use 0W-20 viscosity oil and check the dipstick after refilling to ensure the correct level, as the exact amount can vary slightly.
- Capacity: 5.7 quarts (with filter)
- Oil Type: 0W-20
- Important: Always confirm the final oil level with the dipstick after the oil change, especially after refilling.
How much oil does an Acura take?
The 3.5L V6 engine typically has an oil capacity of 5.7 quarts with a filter.
