How many quarts of transmission fluid does a 1995 Ford Bronco hold?
The 1995 Ford Bronco typically holds about 13 to 15 quarts of automatic transmission fluid, depending on the transmission installed. Most Broncos from that year use the E4OD automatic, which sits in the 13–15 quart range when you account for the torque converter. If a Bronco is equipped with a C6 transmission, the total is commonly closer to 11–13 quarts. Always verify the exact specification for your drivetrain and fill to the recommended level using the vehicle’s dipstick.
Transmission options in the 1995 Bronco
Because the Bronco could be equipped with more than one automatic transmission option in 1995, the fluid capacity depends on the specific unit installed. The following are the typical totals you may encounter.
- E4OD automatic transmission (the most common setup in 1995 Broncos): about 13–15 quarts total capacity, including the torque converter.
- C6 automatic transmission (less common on later-model Broncos): about 11–13 quarts total capacity, including the torque converter.
Note that exact figures can vary slightly by vehicle revision, torque converter size, cooling lines, and filter configuration. Always confirm with your service manual or a dealer for your specific VIN.
How to check and refill the transmission fluid
To ensure proper levels and avoid overfill or underfill, follow these steps carefully. This guidance applies to a warm, running engine and a level parking surface.
Follow these steps to check and refill the transmission fluid safely and accurately.
- With the engine warm, park the Bronco on level ground and apply the parking brake. Leave the engine running and shift through all gears before returning to Park.
- Locate the transmission dipstick (often marked for transmission fluid). Pull it out, wipe it clean, reinsert fully, then pull it out again to read the level.
- If the fluid level is below the "Full" or "Add" mark, add the correct type of transmission fluid gradually using a funnel. Do not overfill.
- Recheck the level after a short drive through the gears to distribute the fluid, then recheck again with the engine running in Park.
- Reinstall the dipstick and close the hood. If you notice persistent low levels or shifting concerns, consult a mechanic.
Regular checks and proper refilling help maintain smooth shifting and extend transmission life. Use the fluid type specified in your owner's manual or by Ford for your exact transmission model.
Summary
For a 1995 Ford Bronco, the transmission fluid capacity largely depends on whether the truck has an E4OD or a C6 automatic. Typical totals are roughly 13–15 quarts for E4OD and 11–13 quarts for C6, including the torque converter. Always verify the exact specification for your vehicle and follow the proper checking and refilling procedure to ensure optimal performance and longevity. In case of uncertainty, refer to the official service manual or contact a Ford dealership.
How many quarts of transmission fluid does a 47RE take?
The 47RE transmission has a total capacity of approximately 14.8 to 16.9 quarts (14-16 liters), while a typical service fill is around 4 to 6 quarts. To properly fill the transmission, add the initial 6 quarts, then start the engine, and add the remaining 7 to 8 quarts in increments while checking the fluid level with the engine running and the transmission in neutral, as per Goerend Transmission.
47RE transmission oil capacity
- Total capacity: 14.8–16.9 quarts (14–16 liters)
- Service fill capacity: Around 4–6 quarts for a basic fluid change
How to fill the transmission
- Add initial fluid: Pour about 6 quarts of transmission fluid into the dipstick tube.
- Start the vehicle: Turn the engine on and let it run for a short while.
- Add more fluid: Add another 7 to 8 quarts of fluid through the dipstick tube.
- Check the level: With the engine running and the transmission in neutral, check the fluid level. Read the dipstick from the low side.
- Top off: Add fluid until it reaches the full mark.
- Final check: Drive the vehicle for 5–10 miles and recheck the fluid level one last time.
How many quarts does an E4OD transmission hold?
The E4OD transmission fluid capacity is approximately 16 to 18 quarts for a full refill with the pan and torque converter drained, but can vary. A simple pan drop and filter change requires a smaller amount, around 6 to 8 quarts. It is crucial to always check the fluid level with the engine running and warmed up after the refill, following the correct procedure for your vehicle.
E4OD transmission fluid capacity
- Full refill (pan and torque converter drained): Around 16 to 18 quarts.
- Pan drop and filter change only: Approximately 6 to 8 quarts.
- Aftermarket cooler: You may need slightly more if you have an aftermarket transmission cooler.
Important tips
- Check the fluid level correctly: After adding fluid, start the engine, let it warm up, and check the dipstick with the engine in park.
- Don't overfill: Overfilling can cause foaming and lead to shifting problems.
- Use the correct fluid: Ford has updated its recommendation from Mercon to Mercon V for some E4OD transmissions. Always verify the correct fluid type for your specific vehicle.
How much transmission fluid does a 1996 Ford Bronco hold?
1992-96 Ford Bronco Transmission Fluid Capacity
5-Speed Manual 4.1qts (Mercron ATF) full capacity. 4-Speed Automatic 16.2qts (Mercron V ATF) full capacity.
What kind of transmission fluid does a 1995 Ford Bronco take?
FRAM – Mercon V Automatic Transmission Fluid: 1 Quart (Part No. F450)
