How many quarts of transmission fluid does a 2008 Dodge Durango take?
About 11 quarts. A full drain-and-fill on a 2008 Dodge Durango, including a new transmission filter, commonly requires roughly 11 quarts of fluid. The exact amount can vary slightly depending on the engine option, drivetrain (rear-wheel drive vs. 4x4), and whether the torque converter is drained. Always verify with the vehicle’s VIN-specific data or the service manual.
What you should know about the Durango’s transmission capacity
The 2008 Durango used a traditional automatic transmission setup, with capacity figures published for typical service scenarios. Because Chrysler offered different engine and drivetrain configurations within that year, the precise fluid capacity can differ by model. When planning a full service, treat 11 quarts as a reliable working estimate and confirm against official specifications for your exact configuration.
Most Durango models use the 545RFE 5-speed automatic
For the common 2008 Durango configuration, the automatic transmission’s total capacity is generally around 11 quarts. If you are performing a pan drain only, the amount drained will be less, and you’ll need to refill to bring the level up to the correct operating mark. Replacing the transmission filter adds a small amount to the total refill requirement, so plan for roughly 11 quarts in total when completing a full service.
Below is a practical checklist to help you prepare and execute a full transmission fluid service.
Checklist before a transmission service:
- Have Dexron/Mercon-compatible transmission fluid on hand (roughly 11 quarts for a full service).
- Replace the transmission filter during the service to maintain proper flow and filtration.
- Use the correct drain procedure for your G/E drivetrain (4x4 may require additional steps to drain the torque converter).
Conclusion for the checklist: Planning for approximately 11 quarts and a new filter will help ensure the system is refilled to the proper level after a full service.
How to determine the exact capacity for your specific Durango
To ensure you get the precise total capacity for your VIN and configuration, use one of these reliable sources and methods.
- Consult the owner’s manual or a factory service manual for your exact Durango model year, engine, and drivetrain.
- Check the dealership service database or a trusted automotive repair database using your VIN.
- Contact a Dodge dealer service department with your VIN to obtain the precise specification for your transmission variant.
By verifying the exact transmission variant and service data for your vehicle, you can confirm the precise total fill amount beyond the general estimate of 11 quarts.
Summary
For a 2008 Dodge Durango, a full transmission fluid service typically requires about 11 quarts, including a new filter. The exact amount can vary with engine choice, drivetrain, and whether you drain the torque converter. Always reference the VIN-specific service data or the official manual to confirm the precise capacity, and consider replacing the filter during a full service to maintain transmission performance.
How many quarts of transmission fluid does a Dodge Durango take?
So there's two. Quarts. All right so we got about three quarts in there. So we're going to put our fill cap back on and then we're going to go in the vehicle.
What kind of transmission fluid does a 2008 Dodge Durango take?
Valvoline ATF +4 Full Synthetic Automatic Transmission Fluid 1 Quart.
How many quarts are needed for a transmission fluid change?
Drivers can expect to pay $125 to $250 for a transmission fluid flush service. This is approximately twice as much as a transmission fluid change. This is due in large part to the additional fluid required. A flush will take 12 to 22 quarts, while a fluid change requires 5 to 7 quarts.
How many quarts of oil does a 2008 Dodge Durango take?
The 2008 Dodge Durango oil capacity varies by engine, but for the common engines it is 7 quarts with a filter for the 5.7L V8 and 6 quarts with a filter for the 4.7L V8. For the 3.7L V6, it is 7 quarts with a filter. Always check the owner's manual and use the recommended oil viscosity for your specific engine.
Engine oil capacity by engine
- 3.7L V6: 7 quarts (with filter)
- 4.7L V8: 6 quarts (with filter)
- 5.7L V8: 7 quarts (with filter)
Important considerations
- These capacities are for an oil and filter change.
- Always consult your owner's manual for the specific oil viscosity and capacity for your vehicle.
- For the 5.7L engine, it is critical to use the correct oil viscosity (SAE 5W-20) to ensure the Multiple Displacement System (MDS) operates correctly.
- Always check the oil level with the dipstick after refilling to ensure it is within the correct range.
