How much does it cost to replace rotors on a Honda?

Typical costs hover around $150 to $350 per axle for rotor-only replacement, and about $250 to $600 per axle if you replace rotors along with new brake pads. Actual prices depend on model, rotor type (OEM vs aftermarket) and local labor rates.

What influences the price

Several factors drive the final bill, including the specific Honda model and rotor size, whether you choose OEM Honda parts or aftermarket equivalents, whether you replace rotors on the front or rear axle, and the prevailing labor rates in your region. Hardware and alignment checks can also affect the overall quote.

Rotor-only replacement on one axle

Before laying out the typical price ranges, note that rotor-only means replacing both rotors on a single axle without changing the brake pads at the same time.

• Parts: aftermarket rotors typically $20-$70 each; OEM Honda rotors about $60-$100 each. For two rotors on one axle, double the figure.


• Labor: average shop rate $90-$120 per hour; job usually takes about 1-2 hours per axle.


• Estimated total per axle (rotor-only): roughly $120-$350, depending on parts quality and local rates.

Rotor-only replacement on a single axle is common when the rotors are worn or warped but the pads have remaining life.

Rotor + pads replacement on one axle

When you replace rotors and pads on one axle, you’ll also pay for new brake pads and possibly updated hardware.

• Parts: pads typically $30-$130 per axle set; rotors $40-$160 for two rotors.


• Labor: 1.5-2.5 hours at $90-$130/hour.


• Estimated total per axle (rotor + pads): roughly $250-$550, with higher-end options for premium rotors or pads.

Customers often choose rotor+pad replacements to restore braking performance and ensure even wear.

Costs by axle and scenario (quick reference)

The following ranges assume common Honda models and typical performance or economy parts. Actual quotes vary by model (Civic, Accord, CR-V), rotor size, and shop rates.

• Front rotor-only replacement (two rotors on front axle): approximately $180-$400 per axle.


• Front rotor + pads replacement on front axle: approximately $320-$600 per axle.


• Rear rotor-only replacement (two rotors on rear axle): approximately $140-$320 per axle.


• Rear rotor + pads replacement on rear axle: approximately $260-$500 per axle.

Note that rotor material and thickness, as well as whether you’re dealing with special brake systems on certain trims, can push costs higher.

What could raise or lower the cost

Here are common factors that affect the final price you’ll see on a quote.

Resurfacing vs replacement

Some shops offer rotor resurfacing (turning) if the rotor is within thickness specs and not warped. This option is less common with newer, cross-drilled or slotted rotors.

• Cost: typically $10-$25 per rotor for resurfacing, plus any service fee.


• Limitations: resurfacing requires the rotor to still meet minimum thickness and be free of excessive wear or damage.

Resurfacing can save money when feasible, but isn’t always possible or advisable for aged or worn rotors.

Parts quality and location

Prices vary based on OEM vs aftermarket parts, and regional differences in labor rates.

• OEM Honda rotors generally cost more than aftermarket equivalents but may offer fit and performance assurances.


• Independent shops in many areas offer competitive pricing compared with dealers.

In most cases, aftermarket rotors paired with quality pads provide a solid balance of cost and performance.

Tips for saving money

Consider these practical steps to keep costs reasonable without compromising braking safety.

• Shop around: obtain quotes from multiple shops and compare what’s included (pads, hardware, disposal fees, taxes).


• Ask about aftermarket or remanufactured rotors: these options are often cheaper than OEM parts with comparable performance.


• Bundle services: replacing rotors and pads in a single visit can reduce labor time and costs compared with separate jobs.


• Check for warranties: some parts come with warranties that protect against warping or premature wear.

Be wary of extremely low quotes, which may reflect subpar parts or incomplete labor coverage.

Summary

Replacing rotors on a Honda typically costs about $150-$350 per axle for rotor-only replacement and $250-$600 per axle if you replace rotors with new brake pads. Front rotors are generally more expensive than rear due to size, and OEM parts cost more than aftermarket equivalents. Labor rates vary by region and shop, with most rotor-only jobs taking roughly 1-2 hours per axle and rotor+pad jobs taking about 1.5-2.5 hours per axle. Resurfacing is sometimes an option, but not always feasible. To get the best value, compare several quotes, confirm which parts and services are included, and consider whether OEM or aftermarket rotors best meet your needs.

How long do rotors last on a Honda?

After bringing your sedan or SUV to a stop numerous times over a period of several years, your vehicle's brake rotors will eventually require replacement. Many factors determine how long your rotors will last, but you can generally expect them to require replacing somewhere between 30,000 and 70,000 miles of driving.

How much does Honda charge for a brake job?

The brake repair cost estimate can vary depending on your vehicle. On average, a brake pad replacement will cost $150 per axle. However, this price range is between $100 to $300 per axle.

Can I drive with bad rotors?

No, you cannot safely drive with bad rotors, especially if they are cracked, as it is a major safety risk due to reduced braking performance and the potential for complete brake failure. Even minor issues like warping can cause vibrations and longer stopping distances, while severe damage can lead to the rotor snapping or the brakes failing completely, endangering you and others. You should get them replaced immediately, driving only for short, necessary trips at low speeds if you absolutely must. 
Dangers of driving with bad rotors

• Reduced braking performance: Worn or warped rotors can't create enough friction, which increases stopping distances and gives you less control over your vehicle. 
• Vibrations: Warped rotors will cause a pulsating or vibrating sensation in the brake pedal and steering wheel when you brake. 
• Increased wear: Bad rotors can accelerate the wear on brake pads and other brake components, potentially leading to more expensive repairs. 
• Risk of brake failure: A rotor can crack or snap, especially if it is worn too thin. This can jam the brake, cause a sudden stop, or even lead to a complete loss of braking on that wheel and potentially the whole system if a brake line is damaged. 
• Safety risk: The most significant danger is a higher risk of an accident due to your inability to stop quickly and effectively. 

You can watch this video to learn about the symptoms of bad brake rotors: 37sHonest Mechanic ColoradoYouTube · Jan 17, 2024
What to do if your rotors are bad

• Avoid driving: Do not drive the vehicle unless it is absolutely necessary. 
• Drive cautiously: If you must drive, do so at a low speed and avoid hard braking. 
• Seek immediate repair: Take your vehicle to a mechanic as soon as possible for an inspection and replacement. 
• Consider replacement: Depending on the damage, you may need to replace the rotors and pads on an axle to ensure balanced braking. 

This video explains when you might need to resurface or replace your brake rotors: 59sBudget MechanicYouTube · Nov 27, 2023

How much to get 4 rotors replaced?

Replacing all four brake rotors typically costs between $600$ 600$600 and $1,200$ 1 comma 200$1,200, which includes parts and labor for most vehicles. However, the final price can vary significantly depending on factors like the vehicle's make and model, the quality of the parts used, and local labor rates. Luxury or performance vehicles will likely be on the higher end of this range or exceed it. 
Cost breakdown and factors

• Parts: Rotors alone can cost anywhere from $100$ 100$100 to $200$ 200$200 each, with larger trucks and SUVs having even more expensive parts. 
• Labor: Expect to pay around $150$ 150$150 to $200$ 200$200 per axle for labor, which is often done in conjunction with replacing the brake pads. 
• Vehicle type: The cost is higher for larger vehicles like trucks and SUVs, as well as for luxury or European models due to more expensive parts. 
• Part quality: Choosing between OEM (original equipment manufacturer) or high-performance parts versus standard aftermarket parts will change the final price. 
• DIY vs. professional: You can save on labor costs by doing the replacement yourself, but this requires the right tools and mechanical knowledge. 

What to do

• Get a quote: Obtain a quote from a few different mechanics to compare prices, considering the total cost including parts and labor. 
• Consider replacing pads too: It is often more cost-effective to replace both the rotors and the pads at the same time, as a full brake job is typically required for both axles. 
• Be wary of "too good to be true" deals: If a quote seems extremely low, it may be an indicator of lower-quality parts or a potential problem with the vehicle that could result in further damage.