How much fluid does a 2014 Subaru Forester front differential take?
The 2014 Subaru Forester front differential takes approximately 0.8 quarts (0.75 liters) of fluid. This fluid is typically a specialized gear oil designed for use in Subaru's all-wheel-drive (AWD) systems.
Detailed Answer
The 2014 Subaru Forester is equipped with a front differential as part of its symmetrical AWD system. The front differential is responsible for distributing power from the transmission to the front wheels, allowing the vehicle to maintain traction and stability on various road conditions.
According to Subaru's maintenance guidelines, the front differential in a 2014 Forester requires periodic fluid changes to ensure proper lubrication and prevent wear on the gears and bearings. The recommended fluid capacity for the front differential is approximately 0.8 quarts (0.75 liters).
It's important to use the correct type of gear oil specified by Subaru, which is typically a synthetic gear oil with a viscosity of 75W-90. Using the wrong fluid or failing to change the fluid at the recommended intervals can lead to premature wear and potential damage to the front differential components.
Fluid Change Procedure
To change the front differential fluid in a 2014 Subaru Forester, you'll need to follow these steps:
- Park the vehicle on a level surface and apply the parking brake.
- Locate the front differential drain and fill plugs, typically located on the bottom and side of the differential housing.
- Using the appropriate wrenches, remove the drain plug and allow the old fluid to drain completely.
- Once drained, replace the drain plug and tighten it securely.
- Locate the fill plug and remove it, then use a fluid transfer pump to add the recommended 0.8 quarts (0.75 liters) of gear oil.
- Continue adding fluid until it begins to drip out of the fill hole, then replace the fill plug and tighten it.
- Start the engine and check for any leaks around the differential housing.
It's recommended to have this service performed by a qualified Subaru technician, as they have the proper tools and expertise to ensure the job is done correctly.
How much fluid does a 2014 Subaru Forester differential take?
Hello, the front differential takes about a quart and a half, and the rear takes a little less than a full quart. Factory specs are 1.5 front, . 8 rear. But this will depend on how much gear oil you can successfully drain out.
How much fluid does a Subaru Legacy front differential hold?
Capacity is 1.3 qts, 75w90 or 80w90 are fine.
How many quarts does front differential take?
1 to 1 1/4 Qts. Add one quart then measure. Add more as needed to get it at the right level but it should not be more than 1 1/4 Qts.
What kind of gear oil does a 2014 Subaru Forester take?
This Fits Your 2014 Subaru Forester. Genuine Subaru Gear Oil Extra MT 75W-80 is uniquely formulated for Subaru manual transmissions. This low viscosity fluid reduces mixing resistance, enables efficient power transfer from engine to tires and provides improved fuel economy.
