Loading

How much oil does a 1995 Chevy Lumina take?

The 1995 Lumina used a couple of V6 engine options, and the oil capacity varies by which engine you have. For the most common 3.1L V6, you’ll typically need about 4.5 quarts of oil with a new filter. If your Lumina uses a larger 3.4L V6 (and in rarer cases a 3.8L variant), the capacity is typically around 5 quarts. Always verify the exact amount with the dipstick and the vehicle’s manual for your specific configuration.


Engine options in the 1995 Lumina


The 1995 Lumina lineup primarily offered the 3.1L V6 as standard, with an optional larger 3.4L V6 in some trims. Some markets or unique configurations could feature different V6 setups, but the numbers below reflect the common U.S. configurations for the year.



  • 3.1L V6 (3100): about 4.5 quarts (approximately 4.3 liters) of oil with a new filter

  • 3.4L V6: about 5 quarts (approximately 4.7 liters) of oil with a new filter

  • 3.8L V6 (present in rare or specialty configurations): about 5 quarts (approximately 4.7 liters) with a new filter


Note: These figures assume a standard oil filter replacement and do not account for additional oil if the filter housing is replaced with a different size or if special drain procedures are used. Always consult the owner’s manual or the under-hood label for your exact engine variant.


Oil change steps and tips


When performing an oil change, following a clear sequence helps ensure you use the correct amount and avoid overfilling. The steps below reflect common practice for this era’s Lumina engines.



  1. Warm the engine slightly, then turn it off and let it cool for about 5–10 minutes to settle the oil.

  2. Place a drain pan under the engine, remove the drain plug, and let the old oil drain completely.

  3. Remove the old oil filter and replace it with a new one of the correct type.

  4. Install the drain plug, then add oil in small increments until the dipstick reads near full. The exact total depends on the engine variant (roughly 4.5 quarts for a 3.1L, about 5 quarts for a 3.4L/3.8L).

  5. Run the engine for a few minutes, turn it off, wait, and recheck the level; add oil if needed to reach the full mark.


Tip: Use a clean funnel and add oil gradually. If you overfill, the dipstick will show above the full line, which can cause foaming and performance issues. Recheck after the engine settles to ensure accuracy.


Summary


The 1995 Chevy Lumina’s oil capacity depends on the engine: about 4.5 quarts for the common 3.1L V6, and around 5 quarts for larger 3.4L (and rare 3.8L) V6 configurations. Always verify the exact amount with the owner’s manual and the dipstick, and adjust for filter changes. Regular, measured oil changes help maintain engine health in this era of GM sedans.

What engine does a 1995 Chevy Lumina have?


Second generation (1995)

Second generation
Engine3.1 L L82/LG8 V6 3.4 L LQ1 DOHC V6 3.8 L L36 V6
Transmission4-speed 4T60-E automatic 4-speed 4T65-E automatic
Dimensions
Wheelbase107.5 in (2,730 mm)



How much oil does a Chevy 4.3 L V6 take?


Engine Oil
Capacity: 6 quarts (with filter).



How much oil does a Chevy Lumina take?


4.5 quarts (with filter).



What oil does a 1995 Chevy Lumina take?


SAE 5W-30
Engine Oil
5W-30 (All TEMPS) - SAE 5W-30 is preferred. Capacity: 5.4 quarts (with filter).


Kevin's Auto

Kevin Bennett

Company Owner

Kevin Bennet is the founder and owner of Kevin's Autos, a leading automotive service provider in Australia. With a deep commitment to customer satisfaction and years of industry expertise, Kevin uses his blog to answer the most common questions posed by his customers. From maintenance tips to troubleshooting advice, Kevin's articles are designed to empower drivers with the knowledge they need to keep their vehicles running smoothly and safely.