How much oil does a 1998 Ford e350 take?
The oil capacity for a 1998 Ford E-350 depends on the engine installed. Gasoline engines in that model typically require about 6 quarts of oil with a new filter, while the larger diesel option (7.3L) needs roughly 14–15 quarts. Always confirm the exact figure for your specific engine by checking the owner’s manual or the engine code under the hood.
Engine options and typical oil capacities
Below are the commonly cited oil capacities for the E-350’s main powertrains from that era. Capacities can vary slightly by exact model, filter size, and whether you’re replacing the oil filter.
- 4.2 L inline-6 gasoline: approximately 6 quarts with the filter (roughly 5.5–6 quarts without the filter).
- 5.4 L V8 gasoline: approximately 6 quarts with the filter (roughly 5.5–6 quarts without the filter).
- 7.3 L diesel (Power Stroke/ID series): approximately 14–15 quarts with the filter (roughly 13–14 quarts without the filter).
When planning an oil change, keep in mind that adding or changing the filter can influence the exact amount needed. After pouring in the oil, run the engine to operating temperature, recheck the dipstick, and top off to the correct level as necessary.
How to confirm the correct capacity for your van
Identify your engine type by checking the VIN, the engine code under the hood, or the owner’s manual. The service manual or Ford’s official specifications for the exact model year will confirm the precise oil capacity for your particular configuration. If in doubt, err on the side of a conservative fill and verify with the dipstick after warming the engine.
Practical tips for maintenance
Regularly inspect the oil level and quality, change oil and filter at the manufacturer-recommended intervals, and use the grade of oil specified for your engine. For older vehicles like the 1998 E-350, using the correct oil viscosity and a quality filter helps preserve engine life and performance.
Summary
Oil capacity for the 1998 Ford E-350 varies by engine: about 6 quarts for the gasoline 4.2L and 5.4L options, and roughly 14–15 quarts for the 7.3L diesel. Always verify the exact requirement for your vehicle with the owner’s manual or by checking the engine code, and adjust after initial filling by using the dipstick to reach the proper level.
How much oil does a 1998 Ford Econoline e350 take?
6 quarts
5W-20 (All TEMPS) - This specification has been updated from 5W-30 to 5W-20 per a Technical Service Bulletin from the manufacturer 5W-20 is the preferred viscosity. Capacity: 6 quarts (with filter). When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.
How much oil does a Ford E350 take?
A Ford E-350 oil capacity varies by model year and engine, ranging from 6 to 8 quarts with a filter change. The 5.4L engine typically uses 6 quarts, while the 7.3L engine takes 8 quarts. Always check your owner's manual to confirm the exact amount and recommended oil viscosity for your specific vehicle.
Common Ford E-350 oil capacities
- 5.4L engine: 6 quarts (with filter)
- 7.3L engine: 8 quarts (with filter)
Important reminders
- Check the owner's manual: The exact amount can vary by year, so always consult your specific E-350's owner's manual for the most accurate information.
- Filter is included: The capacities listed above are for an oil and filter change.
- Check the level: After refilling, start the engine, let it run briefly, and then check the oil level on the dipstick to ensure it is within the correct range.
How many quarts of oil does a 4.0 L V6 take?
The 4.0L V6 oil capacity varies by vehicle, but a common capacity is around 5.5 quarts, though some may need up to 6 quarts. For example, a 2015 Toyota Tacoma with a 4.0L V6 takes about 5.5 quarts for a 4WD model, while a 2007 Nissan Frontier 4.0L V6 takes about 6 quarts with a filter change. Always consult your owner's manual for the exact amount and type of oil required for your specific vehicle.
Oil capacity examples for 4.0L V6 engines
- Toyota Tacoma (2015): Around 5.5 quarts for 4WD models (5.5 quarts with filter).
- Nissan Frontier (2007): Around 6 quarts with a filter change.
- Jeep (engine specific): Around 6 quarts (5.68 L).
- Ford Ranger (2011): Around 5 quarts with a filter change.
How to find the correct capacity
- Check your owner's manual: This is the most reliable source for your specific make and model.
- Use a vehicle-specific online guide: Websites like AMSOIL or Blauparts have lookup tools to find the right oil and capacity for your car.
- Consult a professional: If you are unsure, a mechanic can provide the correct oil and capacity.
How much oil does a 3.8 L V6 take?
A 3.8L V6 engine typically takes between 4.5 and 6 quarts of oil, depending on the specific vehicle and year. For example, a 1994-2004 Ford Mustang with a 3.8L V6 needs about 5 quarts, while a 2007-2011 Jeep Wrangler with a 3.8L V6 takes about 6 quarts. Always check your vehicle's owner's manual or consult a reliable source, like an oil capacity chart, to confirm the exact amount for your specific model, and always check the oil level with the dipstick after refilling.
Here are some examples of oil capacities for different vehicles with a 3.8L V6 engine:
- Ford Mustang (1994-2004): ~5 quarts
- Jeep Wrangler (2007-2011): ~6 quarts
- Pontiac Grand Prix (2008, 3800 V6): ~4.5 quarts
- Buick LeSabre (2000): ~7.4 quarts
