How much oil does a 2000 Dodge Dakota 3.9 take?
The 2000 Dodge Dakota 3.9 requires 4 quarts of oil for a standard oil change. This includes the oil filter replacement as well. The specific oil capacity for this model year and engine size is detailed below.
Oil Capacity for a 2000 Dodge Dakota 3.9
According to the manufacturer specifications, the 2000 Dodge Dakota with the 3.9-liter V6 engine has an oil capacity of 4 quarts, or 1 gallon. This includes the oil filter, which should be replaced during an oil change. The recommended oil type is 5W-30 conventional or synthetic motor oil.
Oil Change Procedure
To change the oil in a 2000 Dodge Dakota 3.9, follow these steps:
- Park the vehicle on a level surface and apply the parking brake.
- Locate the oil drain plug, usually on the bottom of the oil pan, and place a drain pan underneath.
- Unscrew the drain plug and allow the old oil to fully drain out.
- Once drained, replace the drain plug and tighten it securely.
- Locate the oil filter, typically accessible from the top of the engine, and use an oil filter wrench to remove it.
- Apply a thin coat of new oil to the gasket of the new oil filter, then screw it on by hand until secure.
- Unscrew the oil fill cap and pour in 4 quarts of the recommended 5W-30 motor oil.
- Replace the oil fill cap and start the engine, checking for any leaks.
- Allow the engine to run for a few minutes, then check the oil level using the dipstick.
- Top up the oil if necessary to bring the level to the full mark on the dipstick.
Following these steps will ensure your 2000 Dodge Dakota 3.9 is properly serviced with the correct amount of fresh oil. Remember to dispose of the old oil and filter responsibly.
What kind of oil does a 2000 Dodge Dakota 3.9 take?
Oil Grade: API*
10W-30 (Above -18°C) - SAE 10W-30 is preferred. Capacity: 4.5 quarts (with filter).
What is the gas mileage on a 2000 Dodge Dakota 3.9 v6?
15 MPG
How much oil does a 4bt 3.9 take?
10.9 L
General Engine Data:
Displacement 3.9 L [239 cu. in.] Lube System Oil Capacity 10.9 L [2.9 U.S. gal.] Coolant Capacity 7.2 L [1.9 U.S. gal.]
How many quarts of oil does a 2000 Dodge Dakota take?
6 quarts
Capacity: 6 quarts (with filter). After refill check oil level.
How much oil does a Dakota 3.9 take?
4.2 L (4.5 qts.)
What is the specs of the 3.9 Dodge engine?
The 3.9 L is essentially a 5.2 L V8 with two cylinders removed. Power increased substantially to 180 hp (134 kW) at 4,400 rpm and from 195 to 220 lb⋅ft (264 to 298 N⋅m) at 3,200 rpm, as compared with the previous TBI engine.
How many quarts of oil does a Dodge Dakota need?
4 quarts Initial Fill.
How much oil does a 2000 Dodge Dakota 3.9 V6 take?
Capacity: 4.5 quarts (with filter). After refill check oil level.
How many miles do Dodge Dakotas last?
A Dodge Dakota can last around 200,000 to 250,000 miles before the expensive repairs start to pile up. Shop around for one that was used exclusively for work, rather than as a daily driver, and you'll likely get a lot more miles out of it.
Is the 2002 Dodge Dakota 3.9 V6 reliable?
As a whole, consumers found the vehicle's reliability and styling to be its strongest features and value to be its weakest. 829 out of 1461 of owners (57% of them) rank the 2002 Dakota five out of five stars.
