How much oil does a 2007 Ford f450 V10 take?
The engine oil capacity for the 2007 F-450 with the 6.8L V10 is about 6 quarts (5.7 liters) with the filter installed, and about 5 quarts (4.7 liters) if the filter is not replaced.
These figures reflect the standard factory setup for the Triton V10 in that year’s heavy-duty lineup. Variations can occur with aftermarket parts or different sump configurations, so check the owner's manual or your dealer for the exact amount for your VIN.
Oil capacity specifics for the 6.8L V10
Below are the standard capacities used during routine oil changes for this engine:
- Oil capacity with filter installed: 6 quarts (5.7 liters)
- Oil capacity without filter: 5 quarts (4.7 liters)
- Recommended oil viscosity: typically 5W-20 for most climates; 5W-30 in hotter climates or under heavy towing; follow the owner's manual for your vehicle
Remember, these figures guide how much oil to pour during an oil change. Always verify with the dipstick after filling to ensure the level is within the proper range.
Oil-change guidance for the 6.8L V10
When performing an oil change on this engine, follow these general steps to ensure proper drainage and refilling:
- Warm up the engine briefly to loosen oil, then turn it off and safely lift the vehicle if needed.
- Place a drain pan under the oil pan and remove the drain plug to let old oil drain completely.
- Remove and replace the oil filter with a new one, applying a light coat of fresh oil to the gasket.
- Reinstall the drain plug and add 5.7 to 6 quarts of the recommended oil (depending on whether you replace the filter).
- Start the engine, let it run briefly, then turn it off and check the oil level with the dipstick; top off as needed.
Note: Use the correct viscosity for your climate, avoid overfilling, and inspect for leaks after the change.
Summary
The 2007 Ford F-450 with the 6.8L V10 typically requires about 6 quarts (5.7 liters) of engine oil when a filter is replaced, and about 5 quarts (4.7 liters) if the filter isn’t changed. Use 5W-20 or 5W-30 depending on climate, and always verify levels with the dipstick after an oil change. Following these guidelines helps maintain proper lubrication, especially under heavy-duty use.
How much oil does a 2007 Ford e450 6.8 take?
Engine Oil
Capacity: 6.9 quarts (with filter). When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level.
What year is 6.8 V10 to avoid?
For spark plug issues, avoid 1997-2002 and 2004-2008
Or, thanks to thermal expansion differences between the aluminum head and the steel plugs, they essentially become welded in place. Fortunately, 2003 and later V10s don't have these Napoleon-complex plugs.
How much oil does a F450 V10 take?
Engine Oil
Capacity: 7 quarts (with filter).
What oil does a Ford E450 V10 take?
5w-20 EP and 1 qt.
