Loading

How much oil does a 2016 Ford EcoSport take?

About 4.5 quarts (4.3 liters) of engine oil with a filter for the 1.6-liter engine, and roughly 4.0 quarts (3.8 liters) for the 1.0-liter EcoBoost. Exact capacity depends on the engine variant and whether the oil filter is being replaced.


The 2016 Ford EcoSport offered different engines depending on the market, with two common configurations affecting oil capacity. Below is a breakdown of the typical capacities for the two most widely used powerplants in that model year, along with guidance on verifying the precise specification for your vehicle.


Engine options and oil capacity


Before listing the capacities, note that these figures are approximate and intended as a general guide. Always confirm the exact specification for your vehicle in the owner's manual or with a Ford dealer, especially if your EcoSport uses a different engine variant or a different filter setup.



  • 1.6L Ti-VCT I4: about 4.5 quarts (4.3 L) of engine oil with filter.

  • 1.0L EcoBoost I3: about 4.0 quarts (3.8 L) of engine oil with filter.


In short, the 1.6L engine typically requires around 4.5 quarts, while the smaller 1.0L EcoBoost uses about 4.0 quarts. Use the dipstick and your manual to confirm the exact amount for your VIN and oil-change procedure.


Check and maintain oil


To ensure you add the correct amount and maintain proper oil levels, follow these steps:



  1. Park on level ground and turn off the engine; wait 5–10 minutes to let the oil settle.

  2. Open the hood, locate the oil dipstick, pull it out, wipe it clean, reinsert fully, then pull it again to read the level.

  3. If the level is low, add small amounts of oil (about a half-quart at a time), recheck with the dipstick, and avoid overfilling.

  4. Replace the dipstick, secure the oil cap, and run the engine for a minute to circulate the oil. Check for leaks and reset the oil-life monitor if your vehicle is equipped with one.


Following these steps helps ensure you maintain the correct oil level and protect the engine’s longevity. If in doubt, consult the owner's manual or a certified Ford technician for the exact capacity for your specific vehicle.


Summary


The 2016 Ford EcoSport typically takes about 4.5 quarts of engine oil with a filter for the 1.6L engine and about 4.0 quarts for the 1.0L EcoBoost. Capacities vary by market and exact engine variant, so always verify with the owner's manual or dealer for your VIN and use the dipstick as the final check before operating the vehicle.

How many quarts of oil for 2.0 EcoBoost?


The oil capacity for a 2.0L EcoBoost engine is typically 5.7 quarts, although some models and years may use 5.5 quarts. Always confirm the exact amount for your specific vehicle by checking the owner's manual or the oil fill cap. It is important to fill the engine with the recommended amount, then check the dipstick to ensure the level is correct after the oil has drained. 
2.0L EcoBoost oil capacity

  • Most common capacity: 5.7 quarts (or 5.4 L) when changing the oil filter. 
  • Other models: Some models may specify 5.5 quarts (or 5.2 L). 
  • Important: Always refer to your vehicle's owner's manual for the most accurate information.

Tips for changing the oil
  • Check your manual: Verify the correct oil capacity for your specific vehicle model and year. 
  • Use the correct oil: The recommended oil is typically SAE 5W-30. 
  • Filter is included: The specified capacities generally include the amount of oil needed for a new filter. 
  • Check the level: After refilling, start the engine and let it run for a minute to circulate the oil. Turn off the engine, wait a few minutes, and then check the dipstick to ensure the level is within the proper range. 



How many quarts of oil does a Ford EcoSport need?


How much oil does a 2022 Ford EcoSport take? A 2022 Ford EcoSport takes 4.3 quarts of oil.



How many quarts of oil does a 2016 3.5 L EcoBoost take?


The 2016 Ford F-150 3.5L EcoBoost has an oil capacity of 6.0 quarts (5.7 L) with a filter change. It is important to use the correct oil viscosity, typically 5W-30, and after adding the new oil, always check the dipstick to ensure the correct level.
 
Oil capacity and type

  • Capacity: 6.0 quarts (5.7 L) with a filter change
  • Recommended Viscosity: 5W-30 

Important considerations
  • Check the dipstick: After refilling, run the engine briefly to circulate the oil, then turn it off and check the level using the dipstick. Top off as needed to reach the full mark, but avoid overfilling. 
  • Follow specifications: Always refer to your owner's manual for the most accurate information, as specifications can vary. 



How much oil goes in a 1.5 EcoBoost engine?


Capacities and Specifications - 1.5L EcoBoost

ItemCapacity
Engine oil (with oil filter).3.832 L (4.05 qt)
Engine coolant.10.3 L (10.9 qt)
Brake fluid.Between MIN/MAX on brake fluid reservoir
Automatic transmission fluid.8.5 L (9.0 qt)*


Kevin's Auto

Kevin Bennett

Company Owner

Kevin Bennet is the founder and owner of Kevin's Autos, a leading automotive service provider in Australia. With a deep commitment to customer satisfaction and years of industry expertise, Kevin uses his blog to answer the most common questions posed by his customers. From maintenance tips to troubleshooting advice, Kevin's articles are designed to empower drivers with the knowledge they need to keep their vehicles running smoothly and safely.