How much oil does a 2016 Toyota Corolla take?
The engine in most 2016 Toyota Corollas requires about 4.7 quarts (4.4 liters) of oil when you perform an oil and filter change. This figure can vary slightly by market and engine variant, so always check your owner’s manual for the exact specification.
Exact oil capacity for the 2016 Corolla
In the typically equipped U.S. market, the Corolla uses a 1.8-liter four‑cylinder engine. The official capacity with a new oil filter is 4.7 quarts (4.4 liters).
Markets and engines
Note that some overseas markets used different engine variants or configurations, which can affect the stated oil capacity. Always confirm with your manual or a local Toyota technician if you’re not in North America.
Before the capacity details, here are the figures most owners rely on when performing a full oil change.
- Oil capacity with filter: 4.7 quarts (4.4 liters)
- When topping up between changes, use the dipstick to guide additions and avoid overfilling
In practice, most owners perform an oil and filter change using about 4.7 quarts, though exact amounts can vary slightly by engine variant and filter type. Always verify by checking the dipstick after pouring and running the engine.
Oil grade and change interval
The 2016 Corolla commonly requires 0W-20 synthetic motor oil (or an equivalent that meets Toyota’s requirements) for normal operation. The typical interval for synthetic oil under normal driving conditions is up to about 10,000 miles (16,000 kilometers) per Toyota’s maintenance minder, with shorter intervals under severe driving conditions.
Viscosity and brands
Use a 0W-20 synthetic oil that meets API SN or newer standards (Toyota-approved brands are recommended). If local specifications allow, 5W-20 may be an acceptable alternative, but 0W-20 is the most common recommendation for the 2016 Corolla in many markets.
- Oil type: 0W-20 synthetic (Toyota-approved or equivalent)
- Change interval (normal driving with synthetic): up to 10,000 miles (16,000 km)
- Severe driving conditions: shorter intervals; consult your manual
Always refer to your owner’s manual for the exact requirement for your market and engine variant.
How to check oil level
To ensure you don’t overfill and to maintain proper lubrication, follow these steps to check the oil level using the dipstick.
- Park on level ground and turn off the engine. If the engine has been running, wait several minutes for the oil to settle.
- Open the hood, locate the engine oil dipstick, pull it out, wipe it clean, reinsert it fully, and pull it out again to read the level.
- If the oil is below the ADD mark, add oil in small increments (about 1/4 to 1/2 quart) and recheck with the dipstick after each addition.
- Continue until the level sits between the ADD and FULL marks. Do not exceed the FULL line.
- Reinsert the dipstick, close the hood, and run the engine for a minute or two, then recheck again after a few minutes to confirm proper level.
Tip: Always use the recommended oil grade and keep to the maintenance schedule to maximize engine life and performance.
Summary
The 2016 Toyota Corolla’s engine oil capacity is roughly 4.7 quarts (4.4 liters) with the filter for a full oil change. Use 0W-20 synthetic oil in most markets, and follow Toyota’s maintenance minder to determine service intervals. Always verify with your owner's manual for your exact market and engine variant, and regularly check the oil level with the dipstick to avoid overfill.
