How much oil does a 2.4 L Honda Accord take?
About 4.5 quarts (4.3 liters) of engine oil with a new filter, using 5W-20 oil for most models. Always verify the exact amount in your owner's manual or on the under-hood oil capacity sticker for your year and trim.
Oil capacity is generally consistent across the 2.4 L i-VTEC family, but small year-to-year differences can occur, especially with filter size or regional specs. When performing an oil change, drain fully, replace the filter, and add oil gradually until the dipstick reads the full line.
Oil capacity overview
The figures below reflect typical capacities for the 2.4 L Accord engines and assume a new oil filter is installed.
- Typical capacity with filter: 4.5 quarts (approximately 4.3 liters).
- Recommended oil grade: 5W-20 for most years; always consult the owner's manual or under-hood label for your specific model year.
Note: The official capacity is listed for the engine with a new filter. If your service uses a different filter or a special oil change procedure, the exact amount may vary slightly.
Model-year notes
Older generation (roughly 2003–2012)
The 2.4 L i-VTEC used in these Accords typically lists about 4.5 quarts (4.3 L) of oil with a new filter. The recommended viscosity remains around 5W-20, subject to climate and manual specifications.
Newer generation (roughly 2013–2017)
For the mid-2010s 2.4 L i-VTEC variants, capacity remains about 4.5 quarts (4.3 L) with a new filter. As always, verify the precise specification in your owner’s manual or on the vehicle’s oil-capacity sticker.
How to verify and maintain
After an oil change, use the dipstick to confirm the level. Start the engine, let it run briefly, and recheck; top up in small increments if the dipstick indicates below the full mark. Dispose of used oil and filter responsibly.
Summary
In most cases, a 2.4 L Honda Accord requires about 4.5 quarts (4.3 liters) of engine oil when changing the oil with a new filter, using 5W-20 oil. Always confirm the exact capacity for your vehicle year and configuration using the owner’s manual and the under-hood capacity sticker, and follow standard oil-change procedures to ensure an accurate fill.
How much oil does a 2.4 L 4 cylinder engine take?
5.6 quarts (with filter).
How much oil for a 2014 Honda Accord 2.4 L?
The 2014 Honda Accord 2.4L engine has an oil capacity of 4.4 quarts when changing the oil filter, or 4.2 quarts if the filter is not changed. The recommended oil is 0W-20.
- Capacity with filter: 4.4 quarts
- Capacity without filter: 4.2 quarts
- Recommended oil: 0W-20
- Torque for drain plug: 30 ft-lbs
- Important: Always use a new washer on the drain bolt.
How many quarts of oil does a 2016 Honda Accord 2.4 L take?
The 2016 Honda Accord with the 2.4L engine has an oil capacity of 4.4 quarts (4.2 liters) when changing the oil and filter. It is important to use the correct oil type, which is typically 0W-20 synthetic oil, and to always check the dipstick after refilling to ensure the level is correct before driving.
- Capacity: 4.4 quarts (4.2 liters) with a filter change.
- Oil Type: 0W-20 synthetic oil is recommended.
- Procedure: After refilling, start the engine to circulate the oil, then shut it off and check the dipstick to confirm the level is between the low and high marks.
How many quarts of oil for a 2.4 Honda Accord?
Hey guys it's Brian from Airhead Garage. And today we're changing the oil on a 2005 Honda Accord 2.4 4-cylinder.
