How much oil does a 3UZ take?
The 3UZ-FE typically requires about 6.0 quarts (5.7 liters) of engine oil for an oil change with the filter installed. This figure comes from Toyota/Lexus service data and is widely cited by technicians. Exact capacity can vary slightly by model year, filter type, and whether the car has an oil cooler, so always check your owner's manual or service bulletin for your precise configuration.
Official capacity and practical figures
Manufacturers commonly list the 3UZ-FE oil capacity at around 6.0 quarts (5.7 liters) with the filter. This is the standard figure used by dealers and service shops when planning an oil change.
In practice, technicians often confirm the full level by running the engine, letting the oil settle, and then topping up to the Full mark. If your vehicle uses an aftermarket or larger filter, or includes an oil cooler, the total amount needed to reach the Full mark can vary slightly. Always verify with the dipstick after the engine has cooled and settled.
Filling and checking the oil level
When performing an oil change on a 3UZ-FE, follow these steps to ensure you reach the correct level without overfilling:
- Prepare the vehicle on level ground, cool the engine, and drain the old oil while replacing the oil filter.
- Install the drain plug securely and begin by adding oil gradually, aiming for a conservative starting quantity.
- Run the engine for about a minute to circulate the oil, then turn it off and let it settle for several minutes.
- Check the oil level with the dipstick. If it reads below the Full line, add oil in small increments until the dipstick shows the Full mark. The typical total is about 6.0 quarts (5.7 liters) for a standard setup with the OEM filter.
- Run the engine again, recheck for leaks, and recheck the dipstick once the engine cools down.
Note: If you have an aftermarket filter or an oil cooler, refer to the service manual for the exact capacity required to reach the Full mark, as the total can vary slightly from the standard figure.
Tips and caveats
- Always use the oil grade and viscosity recommended in your owner's manual, as climate and driving conditions can affect the ideal specification.
- The 3UZ-FE’s oil capacity is most commonly cited as 6.0 quarts (5.7 liters) with the filter installed; deviations can occur based on hardware changes or model year.
- For peace of mind, perform a final dipstick check after the engine has cooled for a few minutes and top up if necessary.
Summary
The 3UZ-FE V8 typically takes about 6.0 quarts (5.7 liters) of engine oil when changing the oil with a new filter. Always verify the exact capacity for your specific model year and configuration in the owner's manual or Toyota/Lexus service materials, and use the dipstick as the ultimate guide to reach the Full mark.
How many quarts of oil does a Lexus LS430 take?
Project first off the five quarts of 5W30. Oil we're also going to need an oil filter i chose to use the Mobile One oil filter with the product number up on screen we're going to need a 14 mm.
How much oil does a 5.7 Toyota V8 take?
8.5 quarts
2018-2021 Toyota Tundra 5.7L V8 oil change fill capacity is 8.0 liters (8.5 quarts). 2010-2017 Toyota Tundra 5.7L V8 oil change fill capacity is 7.5 liters (7.9 quarts).
What oil does a 3uz take?
5W-30 (All TEMPS) - SAE 5W-30 is preferred.
How much oil does a 5.7 L V8 engine take?
7 quarts
7 quarts, must run and cycle thru the oil filter.
