How much oil does a Ford Focus ST 2.0 Ecoboost take?
About 5 quarts (roughly 4.7 liters) of engine oil, including the filter. This is the typical capacity for the 2.0-liter EcoBoost engine used in the Focus ST, though the exact amount can vary with model year, filter size, and regional specifications. Always check your owner's manual or the dipstick for the precise fill.
The Ford Focus ST equips a turbocharged 2.0L EcoBoost engine that demands careful attention to lubrication. Oil capacity figures are stated with the filter installed, and variations can occur due to changes in filters, oil grade, or engine revisions across years. This article outlines the official capacity, practical steps for changing oil, and best practices to ensure proper lubrication and performance.
Official capacity and how it's specified
Before you drain and refill, understand how Ford states the oil capacity for this engine. The figure you’ll see in manuals or service sheets is typically given as oil capacity with the filter installed. Use this as a baseline and verify with the dipstick and the filter you install.
- Typical capacity: about 5.0 quarts (4.7 liters) including the oil filter.
- Oil type: synthetic 5W-30 is commonly recommended by Ford for the 2.0L EcoBoost, though check your manual for the exact specification and any regional requirements.
- Filter impact: the size and type of the oil filter can affect the total refill amount by a small amount.
Note: The above figures are typical, but exact capacity can vary by model year, regional specification, and hardware changes. Always confirm with the owner's manual or a dealership.
What to do during an oil change
When performing an oil change, the general procedure is to drain all used oil, replace the filter, reinstall the drain plug, and add new oil to reach the full capacity. After starting the engine, let it run for a moment and recheck the level on the dipstick. Add small amounts as needed to reach the proper level.
- Tools you’ll need: new oil that meets Ford spec, new filter, drain pan, funnel, ratchet and sockets.
- Steps: warm the engine, drain oil, replace filter, refill with approximately the target capacity, run the engine, recheck.
- Check interval: typical service interval is every 5,000–7,500 miles (8,000–12,000 km) depending on driving conditions; many owners use 5,000 miles as a safe baseline if using synthetic oil.
Be mindful: If you’re unsure about the exact capacity for your specific year and market, consult the owner's manual or a Ford dealer. They can provide the precise capacity and recommended oil specification for your VIN.
Why the number matters
Oil capacity is not just a number—it affects lubrication, engine wear, fuel efficiency, and warranty coverage. Underfilling can lead to increased engine wear while overfilling can cause oil foaming or damage to catalysts. Always fill to the correct level on the dipstick and use the recommended oil grade and viscosity for your climate and driving conditions.
Common questions about oil in the Focus ST
Here are quick answers to frequent concerns about oil for the Focus ST 2.0 EcoBoost:
- Can I use 5W-20 oil? Some regions require 5W-20; check local Ford service specs for your vehicle.
- Do I need a specific Ford oil? Ford specifies certain grades and specifications (often meeting WSS-M2C930-A or equivalent). Real-world apps often use fully synthetic 5W-30 that meets Ford spec.
- What if I overfill? If you accidentally fill beyond the recommended level, let the engine sit to drain and adjust or drain some oil to correct the level.
Conclusion: The typical capacity is around 5.0 quarts including the filter, but always verify with the manufacturer's documentation for your exact year and trim. The most important steps are using the correct oil type and ensuring the oil level is within the proper range on the dipstick after the change.
Summary
The Ford Focus ST 2.0 EcoBoost typically takes about 5 quarts (4.7 liters) of engine oil, including the filter. Use a synthetic 5W-30 aligned with Ford specs and verify fill level with the dipstick after warming the engine. Always reference your specific model year and region's manual or dealer guidance for the exact capacity, as small variations can occur.
How much oil does a 2013 Ford Focus ST 2.0 take?
Engine Oil
Capacity: 4.5 quarts (with filter).
How many quarts of oil does a Focus ST need?
The oil capacity for a Ford Focus ST (2.0L turbocharged engine) is 5.7 quarts (5.4 liters) when including the oil filter change. The recommended oil type is 5W-30. It is crucial to use the dipstick to check the final level after filling, as capacity can vary slightly.
- Capacity: 5.7 quarts (5.4 liters) with filter
- Oil Type: 5W-30
- Procedure:
- Add about 5.5 quarts of oil.
- Start the engine to circulate the oil.
- Turn off the engine and wait a couple of minutes for the oil to settle.
- Check the dipstick and add the remaining oil slowly until the level is at the top hash mark on the dipstick.
How much oil does a 2017 Focus ST 2.0 take?
We got one car by the way guys it's six quarts. Um the manual I think says about 5 and 1/2 quarts.
How much oil does a 2.0 EcoBoost take?
A 2.0L EcoBoost engine typically requires 5.5 to 5.7 quarts of oil, but the exact amount can vary by model year and specific vehicle. For example, some newer models may specify 6.1 quarts, while older ones might take 5.7 quarts. To be certain, always consult your owner's manual or the sticker under the hood, and after adding oil, check the dipstick to ensure the level is correct.
- Older models: Many models from around 2013-2019, such as the Ford Escape, take approximately 5.7 quarts.
- Newer models: Some newer models specify slightly different capacities, with some as high as 6.1 quarts.
- Always verify: The most accurate source for your specific vehicle is the owner's manual. Check the capacity there and after the oil change, use the dipstick to confirm the level is correct.
