How much oil does a Ford Transit 250 3.5 take?
The Ford Transit 250 with the 3.5-liter engine typically requires about 6 quarts (roughly 5.7 liters) of engine oil, including the oil filter. Exact capacity can vary a little by year, engine variant, and whether a filter is replaced during an oil change.
Oil capacity for common Transit 250 3.5 configurations
Below is a quick breakdown of typical oil capacities for common 3.5-liter gasoline configurations found in Ford Transit 250 models. These figures assume a standard full oil change with a new filter.
- 3.5L EcoBoost V6 (gasoline) with filter: approximately 6 quarts (5.7 liters) of engine oil.
- 3.5L Ti-VCT V6 (non‑EcoBoost) with filter: approximately 6 quarts (5.7 liters) of engine oil.
Note: If you do not change the oil filter, the capacity figure will be slightly less. Always fill to the recommended level on the dipstick after a change and confirm with the owner’s manual for your exact year/model.
Recommended oil type and viscosity
Choosing the right oil is crucial for protection and performance. Ford’s guidance for the Transit’s 3.5L engines typically centers on conventional multi-viscosity oils that meet current API/ILSAC specs, with the following common recommendations.
- Standard viscosity: SAE 5W-20 for normal operating conditions.
- Alternative in hot climates or under heavy towing: SAE 5W-30 may be appropriate.
- Oil specification: Use Ford Motorcraft or another brand that meets API SP or ILSAC GF-6 specifications, as recommended for your year and market.
Always verify the exact viscosity and spec in your owner's manual or with a Ford dealer, since requirements can vary by model year, region, and emission equipment.
Do‑it‑yourself oil change: basic steps
If you’re planning to change the oil yourself, here are the typical steps to follow. This list provides a practical workflow but always consult your manual for any model-year nuances.
- Warm up the engine briefly to loosen oil, then park on a level surface and engage the parking brake.
- Place a drain pan beneath the engine oil sump and remove the drain plug to let old oil drain out fully.
- Remove and replace the oil filter with a new one rated for your engine; apply a small amount of new oil to the gasket on the new filter.
- Reinstall the drain plug securely, then refill the engine with the recommended amount and type of oil (about 6 quarts, or as specified for your exact engine).
- Check the oil level with the dipstick while the engine is off and on a level surface; add oil in small increments if needed until the dipstick reads within the proper range.
- Run the engine for a few minutes, check for leaks, then recheck the dipstick and top up if necessary.
Dispose of used oil and the old filter properly at an approved collection site, and reset any oil-change indicators if present.
Summary
For most Ford Transit 250 models equipped with the 3.5-liter gasoline engine, plan for about 6 quarts (5.7 liters) of oil per change, including a new filter. Use a Ford-approved oil that meets API SP or ILSAC GF-6 specs, typically 5W-20, with 5W-30 as an option for hot climates or heavy towing. Always confirm exact capacity and specification in your owner’s manual or with a dealer, as engine variants and year changes can alter the requirement. When in doubt, consult a qualified mechanic to ensure proper fill and proper disposal of used oil.
How much oil does a 2019 Ford Transit 350 3.5 take?
Engine Oil
Capacity: 5.9 quarts (with filter).
How much oil does a 3.5 V6 take?
The oil capacity for a 3.5L V6 engine is typically around 6 quarts, but it can vary by vehicle model. For a more precise answer, you should check your specific car's owner's manual, as some models require slightly more or less, and the exact amount depends on whether the oil filter is being replaced during the service.
- General estimate: Many 3.5L V6 engines hold about 6 quarts of oil when changing the filter.
- Toyota: The Toyota 3.5L V6, such as in a Camry or Tacoma, often takes around 6.1 quarts with a filter change.
- Ford: Some Ford 3.5L V6 engines, like the EcoBoost in an F-150, use about 6 quarts with a filter change, though some model years or configurations may differ.
- Infiniti: The Infiniti G35 (VQ35DE engine) takes 5.4 liters (about 5.7 quarts) for the engine plus an additional 0.3 liters for the filter, totaling around 5.7 quarts.
- Important: It is always best to consult your vehicle's owner's manual to ensure you are using the correct oil capacity and type.
How much oil does a 3.5 transit 250 take?
12 quarts (with filter).
What oil does a Ford Transit 250 take?
The standard oil for a Ford Transit 250 is 5W-30 full synthetic, with a capacity of 6 quarts for models with the 3.5L engine, though some recent models may require 12 quarts and a 5W-20 or 0W-20 might be recommended for specific climates. Always check your owner's manual for the exact viscosity and capacity for your specific year and engine.
Oil type and viscosity
- Standard: 5W-30 is the most common recommendation for temperatures above -29∘Cnegative 29 raised to the composed with power cap C−29∘𝐶 (-20∘Fnegative 20 raised to the composed with power cap F−20∘𝐹).
- Extreme cold: For climates with temperatures of -30∘Cnegative 30 raised to the composed with power cap C−30∘𝐶 (-22∘Fnegative 22 raised to the composed with power cap F−22∘𝐹) or below, a 0W-20 or 0W-30 oil meeting a specific Ford specification (like WSS-M2C962-A1 or WSS-M2C963-A1) may be recommended.
Capacity
- Varies by model:
- Some models require around 6 quarts.
- Other models with the 3.5L engine require 12 quarts.
- Check your owner's manual: Always verify the exact capacity for your specific year and engine to ensure proper filling.
Important considerations
- Check the level: After adding oil, run the engine for a short time, then let it sit for 10-15 minutes before checking the dipstick to ensure the level is correct.
- Use a quality filter: Use a high-quality oil filter and lubricate the new filter's gasket with a little oil before installing it hand-tight.
- Reset the reminder: After an oil change, remember to reset the "Service Oil" reminder in your vehicle's maintenance menu.
