How much oil does a Toyota Venza 3.5 take?
The Toyota Venza equipped with the 3.5-liter V6 engine typically takes about 6.4 quarts (6.1 liters) of engine oil when performing a full change with the filter, using a full-synthetic 0W-20 oil. Always verify this specification for your exact model year and configuration in the owner's manual or with a Toyota dealer.
Context: what the 3.5L Venza engine means for oil capacity
The Venza’s 3.5-liter V6, part of Toyota’s 2GR-FE family, is shared with several models from roughly the late 2000s to mid-2010s. The standard oil capacity for a drain and fill with a new filter is listed as 6.4 quarts (6.1 liters) in service manuals. This figure applies to non-hybrid Venza models that use the 3.5L V6; if you own a newer or hybrid configuration, or a different engine, check the specific manual for your vehicle year and trim.
Oil specification: what grade to use
Toyota’s guidance for the 3.5L V6 generally calls for a full-synthetic 0W-20 oil that meets current API/ILSAC specifications. Using the recommended grade helps with fuel efficiency, cold-start performance, and engine protection. Always confirm the exact specification for your year and market, as regional requirements can vary.
Do-it-yourself oil-change steps
Before attempting a DIY oil change, gather the correct oil type and capacity, a new filter, a wrench for the drain plug, a funnel, and an oil pan. Here are the basic steps to perform the change on a 3.5L V6 Venza:
Tools and supplies
To perform the change, you’ll want the following items on hand:
- Full-synthetic 0W-20 oil (approximately 6.4 quarts / 6.1 liters)
- New engine oil filter
- Oil drain pan
- Ratchet and socket set (for the drain plug)
- Funnel
- New drain plug crush washer (if applicable)
- Gloves and rags for cleanup
- Jack and stands if you need to lift the vehicle
With the right tools in hand, you can carry out the following steps to complete the oil change:
- Run the engine briefly to warm the oil, then park on a level surface and turn off the engine. Safety first: engage the parking brake and wear protective gear.
- Place the oil pan underneath the drain plug. Remove the drain plug with the appropriate socket and allow the old oil to drain completely. Replace the drain plug washer if your vehicle uses one.
- Remove the old oil filter and install a new filter, applying a light coat of fresh oil to the gasket to ensure a proper seal.
- Reinstall the drain plug securely, then remove the oil filler cap and add the recommended amount of new oil (start with 6.4 quarts and check the level).
- Run the engine for a minute to distribute the oil, turn it off, and check the dipstick. Add more oil if needed to bring the level to the full mark. Inspect for leaks and clean up any spills.
Note: Some steps may vary by model year or trim. Always refer to the service manual or dealer guidance for your exact vehicle, and use quality oils and filters that meet current specifications.
Model year and variant caveats
The 6.4-quart capacity cited here applies to the 3.5L V6 configurations used in the non-hybrid Venza models from the late 2000s to the mid-2010s. If you own a different generation of Venza or a hybrid variant (which uses a 2.5L engine), the oil capacity will differ. Always verify the spec for your exact year and drivetrain in the owner’s manual or with Toyota support.
Summary
For a Toyota Venza with the 3.5-liter V6, plan on about 6.4 quarts (6.1 liters) of engine oil for a full change with a new filter, using a full-synthetic 0W-20 oil. Confirm the specification for your exact model year, trim, and market, and follow the proper steps and safety precautions when performing maintenance.
How many quarts of oil does a 2014 Toyota Venza V6 take?
Oil Grade: API*
| Viscosity: | 0W-20 (All TEMPS) - 0W-20 is the best choice for good fuel economy and starting in cold weather. If 0W-20 is not available 5W-20 may be used. However, it must be replaced with 0W-20 at the next oil change. |
|---|---|
| Capacity: | 6.4 quarts (with filter). After refill check oil level. |
How much oil does a 3.5 L V6 Toyota engine take?
6.1 quarts
3.5L V6 Engine: 6.1 quarts with filter. 2.5L Hybrid Engine: 4.5 quarts with filter.
How much oil does a 2009 Toyota Venza V6 take?
Capacity: 6.4 quarts (with filter). After refill check oil level.
How many quarts of oil does a 3.5 L V6 engine take?
6.0 qt
