How much transmission fluid does a 2007 Chevy Colorado 3.7 take?
For the 2007 Chevrolet Colorado with the 3.7-liter engine, a full transmission fluid service typically requires about 11 to 13 quarts of Dexron VI automatic transmission fluid if you replace the filter, and around 3 quarts for a manual transmission. Exact amounts vary with the specific transmission model and whether you perform a pan drain and fill or a full fluid replacement.
Which transmissions were paired with the 3.7L in the 2007 Colorado?
The 2007 Colorado offered both an automatic transmission and a manual option. The automatic commonly used is the 4L60-E, while the manual option is part of the NV series (often NV3500). The capacities below assume standard service practices for each transmission type.
Automatic transmission (4L60-E) capacity
The 4L60-E automatic in the 2007 Colorado typically uses more fluid than just the pan. The following figures are typical service guidelines:
- Total system capacity (full fill with a new filter): about 11–13 quarts
- Pan-drain-and-fill (pan only, without replacing the filter): roughly 3–5 quarts are replaced
- With a full flush and new external filter: around 11–13 quarts
In short, plan for roughly 11–13 quarts when performing a complete automatic-transmission fluid change with a filter replacement.
Manual transmission capacity
For the manual option commonly paired with the 3.7L, the capacity is approximately 2.7–3.0 quarts of manual transmission fluid, depending on the exact gearbox model and fill procedure.
- Total capacity (typical fill): about 2.7–3.0 quarts
- Drain-and-fill: usually around 2.5–3.0 quarts replaced
In short, for a manual transmission service, expect around 3 quarts of fluid, with small variations by model and fill method.
Practical considerations for measuring and filling
Always use the fluid specification recommended by GM for the vehicle’s transmission. For automatics, this is typically Dexron VI. For manuals, follow the manual’s specification (often GL-4 or GL-5 types, depending on the model). Warm up the vehicle, check fluid level on a level surface, and recheck after cycling through gears to ensure the level is correct.
To get an accurate fill, start with the calculated total capacity for your transmission type, perform the service (pan drain and fill with or without filter replacement for automatics), and then top off slowly as needed to reach the correct dipstick level once the transmission has reached operating temperature.
Summary
The automatic 4L60-E in a 2007 Colorado generally needs about 11–13 quarts of Dexron VI for a full change with a new filter, while the manual NV-series transmission uses around 3 quarts. Always verify the exact capacity for your VIN and transmission code in the owner's manual or a GM service bulletin, and use the correct fluid type. Bottom line: plan for roughly 11–13 quarts for automatic and about 3 quarts for manual during a full service.
Final takeaway
For best results, consult the vehicle’s service manual or a trusted GM service bulletin to confirm your exact transmission code and capacity, then perform the service with the appropriate Dexron VI fluid (automatic) or the recommended manual-spec fluid (manual transmission).
How much transmission fluid does a 2007 Chevy Colorado hold?
5 quarts
How many quarts of transmission fluid does a Chevy Colorado take?
Service every 45,000. It's going to take 6.7 quarts of deck 6 compatible fluid again we use Transend 668 you're going to start by removing. The level check plug.
What kind of transmission fluid does a 2007 Chevy Colorado take?
DEXRON-VI Automatic Transmission Fluid (ATF).
How many quarts of oil does a 2007 Chevy Colorado 3.7 L take?
6 quarts
