How much transmission fluid does a 2007 Lexus ES350 take?
The 2007 Lexus ES350 typically requires about 11 quarts (approximately 10.5 liters) of ATF for a full transmission fluid change; a drain-and-fill usually uses about 6–8 quarts. A complete flush can approach the total system capacity, around 11–12 quarts.
The exact amount depends on whether you perform a drain-and-fill, a full flush, and whether your transmission includes a torque converter drain. Always consult the owner's manual or a factory service manual for the precise specification and the recommended ATF type. Below is a practical breakdown and guidance to help you plan a fluid change.
Capacity overview
These figures reflect common service methods and the overall system capacity for the ES350’s 6-speed automatic. Variations can occur based on production date, transmission model, and whether the pan has a drain plug.
- Full system capacity (total amount of ATF the transmission holds): about 11.0–12.0 quarts (10.4–11.4 liters).
- Drain-and-fill / pan drain only (no torque converter drain): roughly 6.0–8.0 quarts (5.7–7.6 liters).
- Fluid replacement via a full flush (including torque converter): typically up to the full system capacity, around 11.0–12.0 quarts (10.4–11.4 liters).
Note: These estimates assume you are replacing ATF with a compatible Dexron VI-equivalent fluid and that you follow proper warm-up and level-check procedures as described in service guidelines.
ATF type and compatibility
To ensure proper performance and lubrication, use an ATF that meets Lexus/Toyota specifications for the ES350’s 6-speed automatic. The common recommendation is Dexron VI or an equivalent that is approved by Toyota/Lexus for your transmission. Some shops also accept Toyota Genuine ATF WS as an equivalent for certain model years; always confirm with the vehicle’s manual or a certified technician for your VIN.
- Dexron VI or equivalent ATF is typically suitable for this transmission.
- Do not mix ATF types; if you start with one specification, continue with the same throughout the service interval.
- Always verify the exact specification in the owner’s manual or with a Lexus service advisor for your VIN.
Using the correct ATF type helps maintain shifting performance and fluid life. If you have questions about your specific VIN, consult a Lexus dealer or a qualified mechanic for confirmation.
How to plan and perform a change
Before undertaking a change, plan around your desired method and the equipment you’ll use. The ES350’s transmission service approach varies depending on whether you want a simple drain and refill or a full flush. The steps below provide practical guidance for planning the job.
- Determine your service method: drain-and-fill or full flush; confirm with your maintenance provider or manual which yields the capacity figures above.
- Warm up the engine and transmission to operating temperature to ensure the ATF expands to its normal level.
- Place the car on a level surface and safely lift it if needed to access the transmission pan and level-check ports.
- Drain ATF from the pan, replace the gasket, and measure the amount drained to estimate the remaining to be replaced if performing multiple steps.
- Reinstall the pan, refill the transmission with the appropriate ATF in small increments, and recheck the level per the service procedure.
- Test drive the vehicle to warm up and recheck the level; adjust as necessary until the correct level is achieved.
Following these steps helps ensure you replace the correct amount of fluid and maintain proper transmission operation after the service.
Summary
For a 2007 Lexus ES350, plan for roughly 11 quarts of ATF for a full change; drain-and-fill operations typically require about 6–8 quarts, with a full flush using nearly the total capacity. Use Dexron VI or an approved equivalent ATF per the owner's manual, and follow the manufacturer’s level-check procedures. If you’re unsure about your specific VIN or service method, consult a Lexus technician to confirm the exact requirement.
How many quarts of transmission fluid does a 2007 Lexus ES 350 take?
For Automatic Transmission: U660E....WS
| Capacity: | 6 speed U660E Total Fill 6.9 quarts. |
|---|---|
| Capacity: | 3 quarts Initial Fill. |
What transmission fluid for Lexus ES350?
FRAM – Dexron III / Mercon Multi-Vehicle Automatic Transmission Fluid: 1 Quart (Part No. F420)
How many quarts does a 2007 Lexus ES 350 take?
Oil Grade: SL
| Viscosity: | 5W-30 (All TEMPS) - SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 6.4 quarts (with filter). After refill check oil level. |
| Torque: | 30 ft/lbs (Oil Drain Plug) |
What transmission fluid does a 2007 Lexus ES350 take?
Notes: Automatic Transmission Fluid. 1 quart. JWS 3324 or NWS9638 Automatic Transmission Fluid (ATF).
