How much transmission fluid does a 2013 Ford Focus dual clutch take?
The 2013 Ford Focus with a dual-clutch PowerShift transmission typically requires about 9 quarts for a full transmission fluid change, while a simple drain-and-fill generally uses about 4 to 5 quarts. Exact capacity depends on the service type and whether additional components like the cooling circuit or filter are included.
This question hinges on the distinction between a full fluid replacement and a basic drain-and-fill. The PowerShift dual-clutch drivetrain can involve fluid in multiple circuits, and the precise amount deployed can vary by sub-model and whether the transmission filter is replaced during service. For accuracy, consult Ford’s official service documentation or your vehicle’s VIN-specific specification.
Capacity by service type
Before the numbers below, note that service options affect the total amount of fluid needed. A drain-and-fill does not remove all fluid from the system, particularly fluid circulating through cooling lines and other pathways.
- Drain-and-fill: approximately 4–5 quarts (about 3.8–4.7 liters).
- Full transmission service (includes fluid in cooler lines and, if applicable, a new filter): roughly 8–9 quarts (about 7.5–8.5 liters).
- Top-off after a partial drain: keep a small reserve to reach the proper level, typically 0.5–1 quart.
In practice, exact figures can vary by vehicle configuration and year. For the most precise capacity, reference the owner’s manual or a dealer service bulletin, and use the vehicle’s VIN to pull the exact specification. After service, some models may require resetting transmission adaptation values.
Practical tips for performing the service
Gather the Ford-approved transmission fluid type and, if performing a full service, have the replacement filter on hand. Ensure the car is level, warm up the transmission per Ford’s procedure, and follow the recommended steps for filling to the correct level. If you’re unsure, consult a qualified technician.
Summary
For a 2013 Ford Focus with a dual-clutch PowerShift transmission, plan for about 9 quarts for a full fluid change and about 4–5 quarts for a drain-and-fill. Exact capacities vary by VIN and service scope, so verify with official Ford documentation or a dealer before proceeding.
