What brake fluid does a 2004 Acura TSX take?
The 2004 Acura TSX requires DOT 3 brake fluid. This is the standard brake fluid recommended by the manufacturer for this vehicle model.
Detailed Brake Fluid Information for the 2004 Acura TSX
The 2004 Acura TSX is a luxury sedan that was part of Acura's entry-level lineup. Like all vehicles, it requires regular maintenance of its brake system, including periodic brake fluid changes. The manufacturer specifies that DOT 3 brake fluid should be used in this model.
DOT 3 brake fluid is a glycol-based fluid that meets the minimum performance requirements set by the U.S. Department of Transportation (DOT). It has a boiling point of around 401°F (205°C) when new, which helps prevent the fluid from boiling under heavy braking conditions.
It's important to only use the recommended DOT 3 fluid in the 2004 Acura TSX. Using the wrong type of brake fluid can damage the vehicle's brake system components. Brake fluid should be flushed and replaced at the intervals specified in the owner's manual, typically every 2-3 years or 24,000-30,000 miles.p>
Brake Fluid Maintenance Tips
- Only use DOT 3 brake fluid, as specified by Acura for the 2004 TSX model.
- Flush and replace the brake fluid at the recommended service intervals to maintain optimal performance and safety.
- Avoid mixing different types of brake fluids, as this can cause compatibility issues.
- Store brake fluid in a tightly sealed container to prevent moisture contamination.
- Dispose of old brake fluid properly, as it is considered a hazardous material.
Proper maintenance of the brake system, including using the right brake fluid, is crucial for the safe operation of your 2004 Acura TSX. Following the manufacturer's recommendations will help ensure your vehicle's brakes continue to function reliably.
Does it matter what DOT 4 brake fluid I use?
There are several different types of DOT 4 so be certain you use the correct type. DOT 4 is used in some euro and domestic vehicles. DOT 4 Plus is used in Mercedes and Volvo.
How often does Acura recommend replacing brake fluid?
Independent of the Maintenance Minder information, replace the brake fluid every 3 years.
Does the Acura TSX take DOT 3?
Notes: 1 gallon. DOT 3.
How do I know which brake fluid I need?
Also, your vehicle takes a specific type of brake fluid; typically (but not always), DOT3 or DOT4. In newer vehicles, it will often say right on the brake fluid reservoir cap. If not, consult your vehicle's owner's manual. CAUTION: DO NOT USE BRAKE FLUID OTHER THAN THE SPECIFIC TYPE RECOMMENDED FOR YOUR VEHICLE.
What is the Acura TSX code?
A small sticker in your glovebox, on your door jamb, or trunk jamb. The sticker should contain two series of numbers. The top five digit series of numbers is your radio code. The bottom series of numbers is your serial number.
What color is DOT 3 brake fluid vs DOT 4?
DOT 3 Brake fluid: Typically in clear, yellow, blue, and red shades. DOT 4 Brake fluid: Typically in light yellow or crimson red shades. DOT 5 Brake fluid: Typically in purple shades. DOT 5.1 Brake fluid: Typically in clear, yellow, and blue shades.
Can I use DOT 4 in DOT 3 only?
Are DOT 3 and DOT 4 Brake Fluid Compatible? Yes. DOT 3 brake fluid is compatible with DOT 4 brake fluid. However, DOT 4 offers a higher boiling point.
What color is Honda brake fluid?
Brake fluid is normally clear with a slight yellow tint.
What brake fluid does Acura recommend?
Prestone MAX DOT 4 is safe to use in all DOT 4 braking systems, ABS, disc or drum, and can mix with any DOT 4 fluid. Mixing Prestone MAX with other fluids will lower the performance rating for miles and boil points, for best results replace completely with Prestone MAX DOT 4.
What happens if I put DOT 4 instead of DOT 3?
While DOT 3 and DOT 4 can sometimes be used interchangeably, DOT 4 is preferred for systems that generate more heat.
