What is the bolt pattern on a 2018 Ford Focus?
The bolt pattern for the 2018 Ford Focus is 5 lug holes on a 108 mm circle (5x108).
For the 2018 Ford Focus, most models use a 5x108 bolt pattern with a center bore of 63.4 mm. This means five evenly spaced lug studs arranged around a circle with a diameter of 108 millimeters. When shopping for wheels or adapters, confirm this pattern and bore size for your exact vehicle configuration, and consider hub-centric rings if needed to ensure proper centering and fitment.
Bolt pattern specifics
Key measurements you need to know to ensure wheel compatibility are listed below.
- Pattern: 5x108 mm (five lug holes, 108 mm bolt circle)
- Center bore: 63.4 mm
- Commonly used by most 2018 Focus models; confirm with your specific vehicle if unsure
With these specifications in hand, you can compare wheels or hub-centric rings to ensure a proper fit.
How to verify the bolt pattern on your car
Follow these steps to confirm the bolt pattern and fit for your particular 2018 Focus:
- Inspect the factory wheels to count lug holes (should be five) and measure the diameter across opposite holes to verify the 108 mm bolt circle.
- Look inside the wheel hub bore and measure the diameter; 63.4 mm is typical for the 2018 Focus. If the bore is larger, hub-centric rings may be needed for centering; if smaller, wheels will not fit without modification.
- Check official paperwork such as the owner’s manual or the vehicle’s VIN-specific sheet, or confirm with a dealer or tire/wheel retailer for your exact trim and market.
These checks help prevent mounting issues and ensure proper alignment and safety.
Common gotchas and tips
Even with the correct bolt pattern, other wheel specifications matter. Pay attention to wheel width, offset (ET), brake caliper clearance, and tire sizing to avoid rubbing or alignment problems. Always choose wheels that meet or exceed Ford’s recommended specs for your model year and market.
Summary
The 2018 Ford Focus uses a 5x108 bolt pattern with a 108 mm bolt circle and a 63.4 mm center bore. When shopping for wheels, confirm these measurements for your exact car and market, and consider hub-centric rings if the bore or centering differs. Verifying with an expert or the official specs can prevent improper fit and ensure safe, balanced performance.
