What is the width of a 65 Falcon rear end?
The width of a 1965 Ford Falcon rear end is typically around 58 inches. This measurement refers to the distance between the outer edges of the rear axle housing, which houses the differential and wheel bearings. The 65 Falcon's rear end dimensions were designed to accommodate the car's overall size and suspension setup.
Understanding the 65 Falcon Rear End
The 1965 Ford Falcon was a compact car produced by the Ford Motor Company. It featured a rear-wheel-drive layout, with the rear axle and differential located at the back of the vehicle. The rear end, also known as the rear axle assembly, is a critical component that transfers power from the transmission to the rear wheels.
The width of the 65 Falcon's rear end is an important specification, as it affects the car's handling, stability, and overall design. A wider rear end can provide better traction and stability, especially during high-speed cornering or acceleration. However, a wider rear end also requires more space within the vehicle's overall dimensions, which can impact factors like interior room and aerodynamics.
Measuring the Rear End Width
To measure the width of a 65 Falcon's rear end, you would typically measure the distance between the outer edges of the rear axle housing. This measurement is taken at the widest point of the rear end, which is usually near the center of the axle housing.
- Locate the rear axle housing, which is the metal casing that surrounds the differential and wheel bearings.
- Measure the distance between the outer edges of the rear axle housing, using a tape measure or other measuring tool.
- The typical width of a 65 Falcon rear end is around 58 inches, but this can vary slightly depending on the specific model and any modifications made to the vehicle.
Knowing the rear end width is important for anyone working on or modifying a 65 Falcon, as it can impact the selection of replacement parts, suspension components, and other related systems.
How wide is the rear end of a 65 comet?
Here it is again,64/65 Comet/Falcon 8" rearend is 58 inches wide!
How wide is a full width axle?
Full width refers to the width of axles out of a full size truck/van. You are correct they do vary quite a bit. Usually a full width is in the neighborhood of 67-69" WMS for front axles and 66-67" for the rear.
How wide is a 9 inch Ford rear end?
These axles are 65 inches wide from wheel mounting surface to wheel mounting surface (a 68-inch-wide E-series van version is also common), feature the legendary 9-inch diameter ring gear, large Timken set 20 axle bearings, semi-floating 28- or 31-spline axleshafts, drum brakes, and a 5-on-5.5 lug pattern.
How wide is a 1965 Ford Falcon?
Deluxe, 2.8L, Leaded Petrol, 3 SPEED MANUAL
| Dimension | Metric | Imperial |
|---|---|---|
| Ford Falcon Height | 1384 mm | 4 ft 6 in |
| Ford Falcon Width | 1778 mm | 5 ft 10 in |
| Ford Falcon Length | 4602 mm | 15 ft 1 in |
| Ford Falcon Wheelbase | 2781 mm | 9 ft 1 in |
How wide is the rear axle on a 1965 Falcon?
The 1964 & 65 Falcon and Comets V8's had a 58 inch wide 8 inch axle. The match from that is the 1977 to 1981 Granada / Monarch had both the 8 and 9 inch axles or the Lincoln Versailles 9 inch rear end the bonus is that they also have Disk Brakes.
What is the width of a 1963 Falcon rear axle?
A stock 63 falcon V8 is 56 inches, the narrowest 8" ford made. Approximate rear end widths measured from backing plate to backing plate.
What is the value of a 1965 Falcon?
Typically, you can expect to pay around $10,500 for a 1965 Ford Falcon in good condition with average spec. What is the highest selling price of a 1965 Ford Falcon? The highest selling price of a 1965 Ford Falcon at auction over the last three years was $143,000.
What is axle width?
In automobiles (and other wheeled vehicles which have two wheels on an axle), the axle track is the distance between the hub flanges on an axle. Wheel track, track width or simply track refers to the distance between the centerline of two wheels on the same axle.
How do you measure rear end width?
Below. If you like this video. Subscribe here for more curry Tech videos.
What is the width of a 1960 Falcon rear axle?
The 1963 Falcon and Comets Rear Axles as well as the 1960, 1961, 1962 7 1/4 Axels are suppose to be 55.8 Inch Wide.
