What size socket is a 2013 Dodge Charger lug nut?
For the 2013 Dodge Charger, the lug nuts commonly require a 13/16-inch hex socket (about 21 mm). Some aftermarket wheels or trims may use a different size, so always verify with the wheel manufacturer or by measuring the lug nut flats.
Standard lug nut socket size
The Charger’s factory wheels typically use a 13/16-inch hex lug nut with a conical seating surface. If you prefer metric sizing, a 21 mm socket is commonly used, but SAE 13/16" remains the standard for most repair shops.
- 13/16 inch hex (approximately 21 mm)
- Conical (tapered) seating is common on most Charger factory wheels
In practice, the 13/16-inch socket is the default for most 2013 Chargers, but aftermarket wheels or locking lug nuts can change the size. Always confirm by inspecting the lug nut flats or consulting wheel manufacturer specs.
Verifying your wheel and nut size
If you’re unsure whether your particular Charger uses the standard size, use these checks to confirm before buying or forcing a socket onto the lug nut.
How to measure lug nut size
Measure across the flats of the lug nut (the parallel sides). The measurement is the socket size you need (for example, 13/16" or 21 mm). If the lug nuts on your wheels do not match these sizes, your wheels may require different nuts.
- Compare the measurement to common sizes: 13/16" (≈21 mm) or 21 mm socket
- Check for any aftermarket wheel documentation or look up the wheel model online
By verifying the exact lug nut size, you prevent rounding off the nut corners or damaging the lug nuts and wheel hardware.
Safety and usage notes
Use the right tools and follow safe procedures when changing wheels.
- Park on a flat surface, apply parking brake, and chock the opposite wheel.
- Loosen the lug nuts slightly while the car is still on the ground (do not remove yet).
- Jack up the vehicle and remove the wheel, then set it aside.
- Install or remove lug nuts with the correct socket; avoid using power impact without knowing torque specs.
- Torque the lug nuts to the manufacturer’s specification (typically around 100 ft-lbs / 135 Nm for many Chrysler vehicles) in a star pattern, then finish to spec with a torque wrench after lowering the car.
Always consult your owner's manual or a dealer for the exact torque specification for your trim and wheel setup, especially if you have aftermarket wheels.
Summary
The 2013 Dodge Charger most commonly uses a 13/16-inch hex lug nut, which corresponds to about 21 mm. Always verify with your wheel documentation or by measuring the lug nut flats, particularly if you have aftermarket wheels. Use the correct torque and seating style to ensure safe wheel installation.
