What type of oil does a 2024 Acura Integra take?
The 2024 Acura Integra requires 0W-20 synthetic motor oil.
For the Integra’s 1.5-liter turbocharged engine, Acura specifies a fully synthetic 0W-20 that meets API SN/GF-6 standards. This viscosity is chosen to optimize cold-start performance, engine protection, and fuel efficiency. Always verify the exact specification in your owner’s manual or with a dealer, especially if you operate in extreme climates or unusual driving conditions.
Oil specification and rationale
The Integra’s turbocharged 1.5L engine relies on a 0W-20 grade to balance protection during startup with efficiency in operation. Using a thicker oil can compromise startup protection and fuel economy, while significantly thinner oils can affect lubrication under load. Acura’s guidance is to use a high-quality, full-synthetic 0W-20 that meets API SN/GF-6 and ILSAC GF-6 specifications.
- 0W-20 synthetic oil (full synthetic) that meets API SN/GF-6 and ILSAC GF-6
- Examples of commonly used options include: Honda/Acura Genuine 0W-20, Mobil 1 ESP Formula 0W-20, Castrol EDGE 0W-20, Pennzoil Platinum Full Synthetic 0W-20, Valvoline Advanced Full Synthetic 0W-20
Choosing a high-quality 0W-20 synthetic that meets the listed specifications helps protect the engine, preserve warranty coverage, and support optimal fuel economy.
Oil capacity and service interval
Before listing specifics, note the Integra’s oil capacity and typical change timing. The engine holds roughly 3.7 quarts of oil when performing a standard change with a filter, and you should refuel to the correct level after the drain and fill. The oil life monitor provides guidance on replacement timing based on actual driving conditions.
- Oil capacity: about 3.7 quarts (3.5 liters) with filter
- Recommended change interval: typically every 7,500 miles (12,000 km) under normal driving; shorter intervals may apply under severe driving conditions or in extreme temperatures
In practice, following the oil life monitor and your owner's manual will keep the engine properly lubricated and performing at its best.
Choosing the right brand and meeting the spec
Before this list, note that any 0W-20 synthetic oil that meets the API SN/GF-6 and ILSAC GF-6 standards is appropriate for the Integra. Consumers may select from a wide range of reputable brands as long as they meet these specifications.
- 0W-20 synthetic oil that meets API SN/GF-6 and ILSAC GF-6
- Brand options include a variety of fully synthetic 0W-20 products from major manufacturers
Bottom line: Stick to a high-quality 0W-20 synthetic that satisfies the specified standards and perform oil changes at the recommended intervals.
Summary
The 2024 Acura Integra takes 0W-20 synthetic motor oil, with an approximate capacity of 3.7 quarts per change (including the filter). Use a full-synthetic 0W-20 that meets API SN/GF-6 and ILSAC GF-6 standards, and follow the factory interval of about 7,500 miles (or the oil life monitor) for regular maintenance. Always consult the owner’s manual or a dealership for region-specific guidance.
What oil for 2024 Acura Integra?
STP High Mileage Full Synthetic Engine Oil 0W-20 5 Quart.
Can I use 5w30 instead of 5w20 in my Acura?
Everywhere else in the world besides the US, depending on climate, Acura/Honda suggests different viscosities in our J32/J35 engines, ranging from 5w20-10w40. These engines were designed to run on 5w30. You aren't going to hurt anything. Especially if you live somewhere hot.
What kind of oil does a Acura Integra take?
Mobil 1 – Extended Performance Full Synthetic Engine Oil 0W-20, 5 Quart (Part No. 15005)
What kind of oil does a 2025 Integra take?
The 2025 Acura Integra requires 0W-20 full synthetic motor oil. The oil capacity is 3.7 quarts when replacing the filter and 3.4 quarts without the filter.
- Oil type: 0W-20 full synthetic motor oil.
- Oil capacity: 3.7 quarts (with filter change) or 3.4 quarts (without filter change).
- Additional details: It is recommended to use an OE drain plug and a new washer when performing an oil change.
