Where is the fuse on a 2007 Honda Pilot VSA?

The VSA fuse on a 2007 Honda Pilot is located in the engine compartment fuse box and is labeled VSA or ABS/VSA on the fuse box diagram. If you can’t find it there, check the interior fuse box as some related circuits share fuses.

What you should know about VSA fuses

The Vehicle Stability Assist (VSA) system relies on power from a dedicated fuse as part of the ABS/ECU network. A blown fuse will disable VSA and can trigger warning lights on the dash, affecting traction and stability control. Replacing the fuse with the correct rating is a first step in diagnosis, but repeated blows indicate a possible wiring fault or a failing module.

Where to locate the fuses in a 2007 Pilot

There are two fuse boxes in most 2007 Pilots: one in the engine compartment and one inside the cabin. Use the diagrams on the lids to identify the exact VSA/ABS-related fuses for your vehicle’s configuration.

Engine compartment fuse box

Inspect the engine bay fuse box for a fuse labeled VSA or ABS/VSA. The lid diagram shows fuse numbers versus circuits.

• Fuse labeled VSA or ABS/VSA (commonly 7.5A or 10A, depending on production). It is located in the under-hood fuse box.


• Other related ABS/ECU fuses that may affect VSA operation, such as ABS control module or ECU fuses, often share the same box.

In many 2007 Pilots, the VSA fuse is in the engine compartment fuse box and is clearly marked on the diagram under the cover.

Interior fuse box

The interior fuse box is located under the dash on the driver's side. It contains fuses for interior systems; VSA-related fuses are less common here but a few vehicles place ABS/DS fuses in this box. Check the lid diagram for your exact layout.

• Look for fuses labeled ABS, VSA, or ABS/VSA if present on your car’s diagram.


• In some builds, the VSA circuit is not in the interior box; verify with your owner's manual or the fuse box label.

Always replace a blown fuse with the same amperage rating and ensure the fuse and socket are clean and undamaged.

What to do if a fuse keeps blowing

If the VSA fuse blows repeatedly, do not drive the vehicle aggressively. Re-check all related wiring for damage and consider having a qualified mechanic inspect the ABS/VSA control module, wheel speed sensors, or related harnesses, as a fault in one of these components can cause repeated fuse failure.

• Check all connections to the ABS/VSA control module and wheel speed sensors for damage or corrosion.


• Inspect the wiring harness for worn insulation or pinched wires near the ABS components.


• Replace with the recommended fuse rating (as indicated on the fuse box diagram) and monitor the system.

If in doubt, consult a Honda dealership or a certified mechanic for a proper diagnosis.

Summary

For a 2007 Honda Pilot, start by locating the VSA fuse in the engine compartment fuse box, where the fuse diagram on the lid should identify it as VSA or ABS/VSA. If you don’t find a VSA fuse there, check the interior fuse box and your owner’s manual for the exact layout. Replacing a blown fuse is a first step, but recurrent fuse failures point to a possible wiring issue or a faulty ABS/VSA component that should be professionally diagnosed.

Where is the VTM 4 relay on a 2005 Honda Pilot?

Inspect the wiring at the VTM-4 relay, which is located under the dash above the fuse box on the driver's side. Pins 1 (White/Red wire) and 4 (Yellow wire) should have power with the key in the on position, illuminating a test light bulb.

Where is the VSA fuse located?

The VSA fuse box is located under the interior fuse box on the passenger's side of the dashboard. To open it, push the tab and pull up the left side of the cover as shown. The under-hood fuse box is located in the back of the engine compart- ment on the passenger's side.
PDF

How to fix vsa light honda pilot?

To fix the VSA light on a Honda Pilot, first check and inflate your tires to the correct pressure, as low or uneven pressure is a common cause. If that doesn't work, use an OBD-II scanner to find the specific error codes, as the VSA light is often triggered by faults in the wheel speed sensors, ABS system, or brake fluid. Cleaning sensors, checking wiring, topping up brake fluid, and resetting the system are often effective fixes.
 
This video shows common causes of the VSA light and how to fix them: 59sDashboard warning lights YouTube · Dec 14, 2024
Initial checks and resets

• Check tire pressure: Ensure all tires are inflated to the manufacturer's recommended pressure. Uneven or low tire pressure can cause the system to activate. 
• Press the VSA button: If the VSA was manually turned off, press the "VSA Off" button to reactivate it. 
• Check brake fluid: Check the brake fluid reservoir and top it up with the correct Honda-approved fluid if the level is low. 
• Check the battery: A low or failing battery can cause various warning lights to appear. Charge or replace the battery if its voltage is below 12.412.412.4 volts. 

Deeper troubleshooting
This video demonstrates how to perform a VSA calibration: 59sScopelitusYouTube · Aug 31, 2018

• Scan for codes: Use an OBD-II scanner to read the diagnostic trouble codes (DTCs). Many auto parts stores will scan your vehicle for free. 
• Inspect wheel speed sensors: These sensors can become dirty or damaged. Clean any dirt or debris from the sensors and check their wiring for damage or loose connections. 
• Check the brake components: Inspect the brake fluid level and the brake pads. Worn pads can affect the VSA system. 
• Inspect the ABS/VSA module: If the problem persists, the ABS or VSA module may be faulty and require replacement. 

System reset
This video shows how to perform a simple VSA and ABS warning reset: 1mGerard BurkeYouTube · Mar 2, 2020

• Perform a VSA calibration: If the issue was fixed by cleaning sensors or addressing other problems, you may need to reset the system. The calibration procedure can vary by model year, but often involves grounding a specific pin on the OBD-II connector and using the "VSA Off" button to enter a reset mode. 
• Disconnect the battery: As a last resort, you can try disconnecting the negative battery terminal for 10 to 15 minutes to perform a full system reset. 

After performing a fix or reset, drive the vehicle to see if the light remains off. If the VSA light comes back on, it's best to have a professional mechanic diagnose and repair the underlying problem.

What does the VSA light mean on a 2007 Honda Pilot?

The 2007 Honda Pilot VSA light has two meanings: if it blinks, the Vehicle Stability Assist system is actively working to help control a skid; if it stays on, it indicates a system malfunction that requires service. A persistent VSA light can also be accompanied by a warning light with an exclamation mark, often due to a sensor issue, like a failed ABS speed sensor or a problem with the steering sensor (code 84-1). 
When the light blinks

• The VSA system is engaged because the vehicle is in a skid or loss-of-control situation. 
• The system uses the brakes and engine power to help you regain stability. 
• The light will turn off automatically once traction is restored. 

When the light stays on

• The VSA system has detected a malfunction. 
• This often points to a problem with one of the system's sensors, such as a faulty ABS speed sensor. 
• A common cause is a "sensor logic failure" (code 84-1), which relates to the steering neutral position. 
• The system may also be manually turned off via a button on the dashboard. If you see the light, check if you accidentally pressed the "VSA OFF" button and press it to turn it back on. 

What to do

• If the light is blinking: Keep driving cautiously and avoid sudden movements until the light goes out. 
• If the light is solid:
  • Turn the vehicle off, wait a few minutes, and then restart it. The light may clear. 
  • Check the tires to ensure they are all properly inflated, as incorrect pressure can trigger the light. 
  • If the light remains on, have the vehicle serviced by a professional. A specialized scan tool is often needed to read the specific codes and diagnose the problem correctly. 
  • Be aware that issues with other systems, such as a misfiring engine, can also cause the VSA light to come on.